Molecularly ordered decanethiolate self-assembled monolayers on Au(111) from in situ cleaved decanethioacetate: an NMR and STM study of the efficacy of reagents for thioacetate cleavage.

The cleavage of decanethioacetate (C10SAc) has been studied by (1)H nuclear magnetic resonance (NMR) spectroscopy and scanning tunneling microscopy (STM) imaging of in situ prepared decanethiolate self-assembled monolayers (SAMs) on Au(111). Solutions of C10SAc (46 mM) and previously reported cleavage reagents (typically 58 mM) in CD(3)OD were monitored at 20 degrees C by NMR spectroscopy. Cleavage by ammonium hydroxide, propylamine, or hydrochloric acid was not complete within 48 h; cleavage by potassium carbonate was complete within 24 h and that by potassium hydroxide or 1,8-diazabicyclo[5.4.0]undec-7-ene (DBU) within 2 h. Similar cleavage rates were observed for phenylthioacetate. The degree of molecular ordering determined by STM imaging increased with increasing extent of in situ cleavage by these same reagents (2.5 mM C10SAc and 2.5 mM reagent in ethanol for 1 h, then 16 h immersion of Au/mica). Less effective cleavage reagents did not cleave the C10SAc sufficiently to decanethiol (C10SH) and gave mostly disordered SAMs. In contrast, KOH or DBU completely cleaved the C10SAc to C10SH and led to well-ordered SAMs composed of (square root(3) x square root(3))R30 degrees domains that are indistinguishable from SAMs grown from C10SH. Monolayer formation from thioacetates in the absence of cleavage agents is likely due to thiol or disulfide impurity in the thioacetates. Eliminating disulfide by using Bu(3)P as a sacrificial reductant also helped to produce good molecular order in the SAM. The methods presented here allow routine growth of molecularly ordered alkanethiolate SAMs from thioacetates using reagents of ordinary purity under ambient, benchtop conditions.