Literature DB >> 20585881

Simulation of the influence of industrial wastewater on a municipal sewage treatment plant--a case study.

Ákos Rédey1, Viola Somogyi, József Ányos, Endre Domokos, Péter Thury, Tatiana Yuzhakova.   

Abstract

PURPOSE: Industrial wastewater flow caused operational difficulties in the wastewater treatment plant in Debrecen, Hungary. Bioaugmentation was successfully applied to maintain effluent quality in the periods when wastewater of high starch content was accepted, but, at the end of 2008, the nitrification capacity of the plant decreased considerably due to improperly pre-treated pharmaceutical wastewater. METHODS AND MATERIAL: Dynamic simulations were carried out in a prototype programme developed by the Environmental Expert System Research Group at the University of Pannonia, Hungary. Several parameters for heterotrophic biomass were adjusted in function of time, and the specific growth rate of autotrophic biomass was altered in function of time and temperature in order to describe the effects of inoculation and toxic influence. Simulations were carried out with both constant and adjusted parameters.
RESULTS: Though results on effluent COD of the different modelling versions were similar, the ammonia concentration fitted the measured data only when modified parameters were used. The study revealed that the autotrophic biomass had slowly adapted to the toxic compound. Different control strategies of aeration and decreased excess sludge removal rate were tested to enhance the nitrification in the critical time intervals. The amount of ammonia and inorganic nitrogen decreased in all cases while the oxygen demand increased to a maximum of 10.1%.
CONCLUSIONS: Reducing excess sludge removal rate gave satisfactory results even without changing aeration. Further improvement could be achieved by introducing aeration into the post-denitrification reactor. The combination of the two modifications can compensate for the effect caused by toxicity.

Entities:  

Mesh:

Substances:

Year:  2010        PMID: 20585881     DOI: 10.1007/s11356-010-0362-7

Source DB:  PubMed          Journal:  Environ Sci Pollut Res Int        ISSN: 0944-1344            Impact factor:   4.223


  3 in total

1.  A practical protocol for dynamic modelling of activated sludge systems.

Authors:  J J W Hulsbeek; J Kruit; P J Roeleveld; M C M van Loosdrech
Journal:  Water Sci Technol       Date:  2002       Impact factor: 1.915

2.  Experience with guidelines for wastewater characterisation in The Netherlands.

Authors:  P J Roeleveld; M C M van Loosdrecht
Journal:  Water Sci Technol       Date:  2002       Impact factor: 1.915

3.  Characterization of the toxic effects of cadmium and 3.5-dichlorophenol on nitrifying activity and mortality in biologically activated sludge systems-effect of low temperature.

Authors:  Vaitea Pambrun; Aurélien Marquot; Yvan Racault
Journal:  Environ Sci Pollut Res Int       Date:  2008-08-21       Impact factor: 4.223

  3 in total
  2 in total

1.  RO/NF membrane treatment of veterinary pharmaceutical wastewater: comparison of results obtained on a laboratory and a pilot scale.

Authors:  Davor Dolar; Tatjana Ignjatić Zokić; Krešimir Košutić; Danijela Ašperger; Dragana Mutavdžić Pavlović
Journal:  Environ Sci Pollut Res Int       Date:  2012-04-29       Impact factor: 4.223

2.  A Visual Basic simulation software tool for performance analysis of a membrane-based advanced water treatment plant.

Authors:  P Pal; R Kumar; N Srivastava; J Chaudhuri
Journal:  Environ Sci Pollut Res Int       Date:  2013-08-28       Impact factor: 4.223

  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.