| Literature DB >> 20471057 |
Wonjae Chang1, Michael Dyen, Lou Spagnuolo, Philippe Simon, Lyle Whyte, Subhasis Ghoshal.
Abstract
This study evaluates the feasibility of landfarming biotreatment of petroleum-contaminated soils obtained from a sub-Arctic site at Resolution Island, Nunavut, Canada, and evaluates the changes in composition of the semi- and non-volatile petroleum hydrocarbon fractions during the biotreatment. Pilot-scale landfarming experiments were conducted in a laboratory in soil tanks under temperature profiles representative of the 3-year site air temperatures in July and August where temperature varied uniformly between 1 degrees C and 10 degrees C over 10 d. The site soils were acidic and N-deficient, but contained indigenous populations of hydrocarbon-degrading microorganisms. Biostimulation with nitrogen and phosphorus nutrient amendments to achieve C(TPH):N:P molar ratio of 100:9:1, and CaCO(3) amendment at 2000 mg Kg(-1) for maintaining neutral pH, and periodic 10-day tilling, reduced total petroleum hydrocarbon (TPH) concentrations by up to 64% over a 60-day period. The rate and extent of semi-volatile (F2: >C10-C16) and non-volatile (F3: >C16-C34) petroleum hydrocarbon fractions in the landfarms containing higher initial TPH levels ( approximately 2000 mg Kg(-1)) and lower TPH levels ( approximately 1000 mg Kg(-1)) were compared. Significant biodegradation of the F2 and F3 fractions occurred in both of those systems. First-order biodegradation rate constants of up to 0.019+/-0.001 d(-1) were determined for the F3 hydrocarbon fraction and were similar to the F2 fraction biodegradation rate constants of up to 0.024+/-0.005 d(-1). Biodegradation profiles of the C14, C16 and C18 alkanes revealed that at TPH concentrations above 1000 mg Kg(-1) these compounds are degraded concurrently, whereas below 1000 mg Kg(-1) the higher-molecular weight alkanes are preferentially degraded. After the 60-day treatment period, the TPH concentration was approximately 500 mg Kg(-1), and the residual TPH mass was largely associated with particles and aggregated particles with diameters of 0.6-2 mm, rather than the larger or finer particles and aggregates. Copyright (c) 2010 Elsevier Ltd. All rights reserved.Entities:
Mesh:
Substances:
Year: 2010 PMID: 20471057 DOI: 10.1016/j.chemosphere.2010.03.055
Source DB: PubMed Journal: Chemosphere ISSN: 0045-6535 Impact factor: 7.086