Literature DB >> 20188961

Ionic liquid-based single-drop microextraction followed by liquid chromatography-ultraviolet spectrophotometry detection to determine typical UV filters in surface water samples.

Lorena Vidal1, Alberto Chisvert, Antonio Canals, Amparo Salvador.   

Abstract

A user-friendly and inexpensive ionic liquid-based single-drop microextraction (IL-SDME) procedure has been developed to preconcentrate trace amounts of six typical UV filters extensively used in cosmetic products (i.e., 2-hydroxy-4-methoxybenzophenone, isoamyl 4-methoxycinnamate, 3-(4'-methylbenzylidene)camphor, 2-ethylhexyl 2-cyano-3,3-diphenylacrylate, 2-ethylhexyl 4-dimethylaminobenzoate and 2-ethylhexyl 4-methoxycinnamate) from surface water samples prior to analysis by liquid chromatography-ultraviolet spectrophotometry detection (LC-UV). A two-stage multivariate optimization approach was developed by means of a Plackett-Burman design for screening and selecting the significant variables involved in the SDME procedure, which were later optimized by means of a circumscribed central composite design. The studied variables were drop volume, sample volume, agitation speed, ionic strength, extraction time and ethanol quantity. Owing to particularities, ionic liquid type and pH of the sample were optimized separately. Under optimized experimental conditions (i.e., 10 microL of 1-hexyl-3-methylimidazolium hexafluorophosphate, 20 mL of sample containing 1% (v/v) ethanol and NaCl free adjusted to pH 2, 37 min extraction time and 1300 rpm agitation speed) enrichment factors up to ca. 100-fold were obtained depending on the target analyte. The method gave good levels of repeatability with relative standard deviations varying between 2.8 and 8.8% (n=6). Limits of detection were found in the low microg L(-1) range, varying between 0.06 and 3.0 microg L(-1) depending on the target analyte. Recovery studies from different types of surface water samples collected during the winter period, which were analysed and confirmed free of all target analytes, ranged between 92 and 115%, showing that the matrix had a negligible effect upon extraction. Finally, the proposed method was applied to the analysis of different water samples (taken from two beaches, two swimming pools and a river) collected during the summer period. (c) 2009 Elsevier B.V. All rights reserved.

Entities:  

Year:  2010        PMID: 20188961     DOI: 10.1016/j.talanta.2009.12.042

Source DB:  PubMed          Journal:  Talanta        ISSN: 0039-9140            Impact factor:   6.057


  5 in total

1.  Occurrence of pharmaceuticals and UV filters in swimming pools and spas.

Authors:  Yuli Ekowati; Gianluigi Buttiglieri; Giuliana Ferrero; Jennifer Valle-Sistac; M Silvía Diaz-Cruz; Damià Barceló; Mira Petrovic; Marta Villagrasa; Maria D Kennedy; Ignasi Rodríguez-Roda
Journal:  Environ Sci Pollut Res Int       Date:  2016-04-11       Impact factor: 4.223

2.  Sensitive determination of terazosin in pharmaceutical formulations and biological samples by ionic-liquid microextraction prior to spectrofluorimetry.

Authors:  Mohsen Zeeb; Mahdi Sadeghi
Journal:  Int J Anal Chem       Date:  2012-02-08       Impact factor: 1.885

3.  Multi-Residue Analysis of Chemical Additives in Edible Vegetable Oils Using QuEChERS Extraction Method Followed by Supercritical Fluid Chromatography.

Authors:  Yaping Gan; Yan Zhu
Journal:  Molecules       Date:  2022-03-03       Impact factor: 4.411

4.  Determination of Benzophenones in Water and Cosmetics Samples: A Comparison of Solid-Phase Extraction and Microextraction by Packed Sorbent Methods.

Authors:  Grażyna Wejnerowska; Izabela Narloch
Journal:  Molecules       Date:  2021-11-16       Impact factor: 4.411

5.  Modified ionic liquid cold-induced aggregation dispersive liquid-liquid microextraction combined with spectrofluorimetry for trace determination of ofloxacin in pharmaceutical and biological samples.

Authors:  M Zeeb; M R Ganjali; P Norouzi
Journal:  Daru       Date:  2011       Impact factor: 3.117

  5 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.