Literature DB >> 20145885

Hygroscopic properties of the workroom aerosol in aluminium smelter potrooms: a case for transport of HF and SO2 into the lower airways.

S Weinbruch1, N Benker, W Koch, M Ebert, P A Drabløs, N P Skaugset, D G Ellingsen, Y Thomassen.   

Abstract

The hygroscopic behaviour of individual aerosol particles from workplaces in a primary aluminium smelter was investigated by environmental scanning electron microscopy. At a high relative humidity, comparable with the human respiratory tract, most particles encountered in the Søderberg and Prebake potrooms either undergo partial deliquescence (leading to a water droplet with an insoluble core) or form thin water films at the surface. As gaseous HF and SO(2) are highly soluble in water, the aerosol particles may act as carrier for these two gases into the alveolar region of the lower respiratory tract. Based on a one-dimensional mass balance model, it is estimated that under peak exposure conditions (particle surface area concentration of 10(-4) cm(2) cm(-3)) approximately 10% of the initial gaseous HF may be transferred to the particle phase. For SO(2), this fraction is much lower (approximately 1%). These results indicate that at least HF may penetrate deeper into the lung in the presence of soluble particles or particles that form surface water films compared to HF alone.

Entities:  

Mesh:

Substances:

Year:  2009        PMID: 20145885     DOI: 10.1039/b919142a

Source DB:  PubMed          Journal:  J Environ Monit        ISSN: 1464-0325


  4 in total

1.  Development of a job-exposure matrix for exposure to total and fine particulate matter in the aluminum industry.

Authors:  Elizabeth M Noth; Christine Dixon-Ernst; Sa Liu; Linda Cantley; Baylah Tessier-Sherman; Ellen A Eisen; Mark R Cullen; S Katharine Hammond
Journal:  J Expo Sci Environ Epidemiol       Date:  2013-09-11       Impact factor: 5.563

Review 2.  Systematic review of potential health risks posed by pharmaceutical, occupational and consumer exposures to metallic and nanoscale aluminum, aluminum oxides, aluminum hydroxide and its soluble salts.

Authors:  Calvin C Willhite; Nataliya A Karyakina; Robert A Yokel; Nagarajkumar Yenugadhati; Thomas M Wisniewski; Ian M F Arnold; Franco Momoli; Daniel Krewski
Journal:  Crit Rev Toxicol       Date:  2014-10       Impact factor: 5.635

3.  Particle Size Distribution in Aluminum Manufacturing Facilities.

Authors:  Sa Liu; Elizabeth M Noth; Christine Dixon-Ernst; Ellen A Eisen; Mark R Cullen; S Katharine Hammond
Journal:  Environ Pollut (Tor)       Date:  2014-09-24

Review 4.  The aluminum smelting process and innovative alternative technologies.

Authors:  Halvor Kvande; Per Arne Drabløs
Journal:  J Occup Environ Med       Date:  2014-05       Impact factor: 2.162

  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.