Literature DB >> 20105459

Deeper insight into the drug release mechanisms in Eudragit RL-based delivery systems.

B Glaessl1, F Siepmann, I Tucker, T Rades, J Siepmann.   

Abstract

Tartaric acid, metoprolol free base and metoprolol tartrate act as plasticisers for Eudragit RL, in the dry but also in the wet state. Fitting analytical solutions of Fick's second law of diffusion allowed for the determination of the apparent diffusivities of water and of tartaric acid, metoprolol free base and metoprolol tartrate upon exposure of thin films to 0.1M HCl, phosphate buffer pH 7.4 and distilled water. Based on these calculations, it could be shown that water penetration into the systems is predominantly controlled by pure diffusion, irrespective of the type of bulk fluid. Interestingly, the plasticising effect of metoprolol tartrate was much more pronounced than that of tartaric acid, resulting in monotonically increasing diffusion coefficients with increasing initial drug content. In contrast, the plasticising activity of metoprolol free base was very limited in the wet state, due to drug precipitation in aqueous environments. Partially observed film shrinking (after an initial system swelling) could be attributed to the leaching of the plasticising compound into the release medium, resulting in less flexible polymeric networks and squeezing out of water. Also the release of tartaric acid, metoprolol free base and metoprolol tartrate into the investigated bulk fluids was predominantly diffusion controlled. However, the precipitation of the free base in wet films rendered the mass transport mechanisms more complex, at moderate and high initial drug loadings. The obtained new insight into the underlying drug release mechanisms in Eudragit RL networks can help to facilitate the optimisation of this type of dosage forms. Copyright 2010 Elsevier B.V. All rights reserved.

Entities:  

Mesh:

Substances:

Year:  2010        PMID: 20105459     DOI: 10.1016/j.ijpharm.2010.01.031

Source DB:  PubMed          Journal:  Int J Pharm        ISSN: 0378-5173            Impact factor:   5.875


  4 in total

1.  Evaluation of drug release profile from patches based on styrene-isoprene-styrene block copolymer: the effect of block structure and plasticizer.

Authors:  ChengXiao Wang; Wei Han; XiuZhen Tang; Hao Zhang
Journal:  AAPS PharmSciTech       Date:  2012-04-03       Impact factor: 3.246

2.  Preparation and evaluation of sustained-release matrix tablets based on metoprolol and an acrylic carrier using injection moulding.

Authors:  T Quinten; G P Andrews; T De Beer; L Saerens; W Bouquet; D S Jones; P Hornsby; J P Remon; C Vervaet
Journal:  AAPS PharmSciTech       Date:  2012-09-11       Impact factor: 3.246

3.  Coatings of Eudragit® RL and L-55 Blends: Investigations on the Drug Release Mechanism.

Authors:  Robert Wulff; Claudia S Leopold
Journal:  AAPS PharmSciTech       Date:  2015-08-12       Impact factor: 3.246

4.  Relationship between Degree of Polymeric Ionisation and Hydrolytic Degradation of Eudragit® E Polymers under Extreme Acid Conditions.

Authors:  Valentina Linares; Cristhian J Yarce; Juan D Echeverri; Elkin Galeano; Constain H Salamanca
Journal:  Polymers (Basel)       Date:  2019-06-07       Impact factor: 4.329

  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.