Effect of solution chemistry on arsenic sorption by Fe- and Al-based drinking-water treatment residuals.

Drinking-water treatment residual (WTR) have been proposed as a low-cost alternative sorbent for arsenic (As) - contaminated aquatic and soil systems. However, limited information exists regarding the effect of solution chemistry on As sorption by WTR. A batch incubation study was carried out to investigate the effect of solution pH (3-9) on As(V) sorption by Al- and Fe-based WTR as a function of solid: solution ratio (SSR) and initial As concentration. The effect of competing ligands (phosphate-P(V) and sulfate), and complexing metal (calcium) on As(V) sorption envelopes at the optimum SSR (200gL(-1)) was also evaluated. At 200gL(-1) SSR, maximum As(V) sorption ( approximately 100%) exhibited by the Fe-WTR was limited at the pH range of 3-7, whereas, the Al-WTR demonstrated approximately 100% As(V) sorption in the entire pH range. The negative pH effect on As(V) sorption became more pronounced with increasing initial As concentrations and decreasing SSR. Sorption of As(V) by surfaces of both WTR decreased in the presence of P(V), exhibiting strong pH dependence. Only for the Fe-WTR, increased dissolved iron concentrations at pH>7 supported a Fe-hydroxide reductive dissolution mechanism to account for the enhanced As sorption at alkaline pH. Addition of sulfate did not influence As(V) sorption by both WTR. A cooperative effect of calcium on As(V) sorption was observed at alkaline pH due to the formation of a calcium-arsenate phase. The constant capacitance model provided reasonable fits to the sorption envelope data for both single ion and binary ion (As and P) systems, but it was unable to explain the enhanced As sorption by the Fe-WTR at pH>7.