| Literature DB >> 19917074 |
Mark Q Benedict1, Bart G J Knols, Hervé C Bossin, Paul I Howell, Eric Mialhe, Carlos Caceres, Alan S Robinson.
Abstract
Mosquitoes, just as other insects produced for the sterile insect technique (SIT), are subjected to several unnatural processes including laboratory colonisation and large-scale factory production. After these processes, sterile male mosquitoes must perform the natural task of locating and mating with wild females. Therefore, the colonisation and production processes must preserve characters necessary for these functions. Fortunately, in contrast to natural selection which favours a suite of characteristics that improve overall fitness, colonisation and production practices for SIT strive to maximize only the few qualities that are necessary to effectively control populations. However, there is considerable uncertainty about some of the appropriate characteristics due to the lack of data. Development of biological products for other applications suggest that it is possible to identify and modify competitiveness characteristics in order to produce competitive mass produced sterile mosquitoes. This goal has been pursued--and sometimes achieved--by mosquito colonisation, production, and studies that have linked these characteristics to field performance. Parallels are drawn to studies in other insect SIT programmes and aquaculture which serve as vital technical reference points for mass-production of mosquitoes, most of whose development occurs--and characteristics of which are determined--in an aquatic environment. Poorly understood areas that require further study are numerous: diet, mass handling and genetic and physiological factors that influence mating competitiveness. Compromises in such traits due to demands to increase numbers or reduce costs, should be carefully considered in light of the desired field performance.Entities:
Mesh:
Year: 2009 PMID: 19917074 PMCID: PMC2777326 DOI: 10.1186/1475-2875-8-S2-S4
Source DB: PubMed Journal: Malar J ISSN: 1475-2875 Impact factor: 2.979
Figure 1Cut-away view of a concept pupa-larva separator for continuous mechanized operation. A continuous mixed stream of larvae and pupae flow into a rotating drum consisting of parallel tapered discs. The anticipated diameter of the drum is approximately 40 cm. Because of their greater effective size, pupae (circles) are captured in the slots whereas larvae (rectangles) flow through and are caught in a tray from which they can be returned to culture trays to complete development. As the drum rotates, the pupae move upward and beneath a spray bar dislodging them into a collection tray. The design could be modified for various-sized species by changing the disc taper and amount of the space between disks.
Figure 2A concept adult colonisation and production cage. The cage base measures approximately 1 × 1 m and is approximately 1.8 m high. The bottom sides are rigid and consist of aluminium sheets. The sides and dark resting louvers slope inward to minimize excretion of resting adults onto cage mates. The bottom of the cage is covered with newsprint paper fed into the cage from a roll to allow simple renewal. The appliances consist of devices for egg collection, pupa introduction, blood and sugar feeding tubes. Each is open over part of its length for adult access. The tubular design allows removal of the tubes for cleaning and would allow solutions to circulate through them if desired. All activities associated with such a cage could be mechanized or centrally performed without opening the cage. A cage of this design has been constructed by the authors as have many of the appliances. An artificial horizon as described by Marchand [13] is created between the lower dark portion and the upper translucent cloth cover. We have observed mating swarms occurring at the interface as by Marchand (Figure 3).
Figure 3Adult . The effectiveness of the artificial horizon in the cage shown in Figure 2 is seen by swarming occurring during an artificial dusk.