Literature DB >> 19680089

Biomechanical evaluation of the vertebral jack tool and the inflatable bone tamp for reduction of osteoporotic spine fractures.

Maurits S Sietsma1, Allard J F Hosman, N J J Verdonschot, Arthur M M Aalsma, Albert G Veldhuizen.   

Abstract

STUDY
DESIGN: Controlled in vitro study.
OBJECTIVE: To compare two kyphoplasty techniques in cadaveric fractured vertebrae: an experimental vertebral jack tool (VJT) and an inflatable bone tamp (IBT). SUMMARY OF BACKGROUND DATA: A previous biomechanical study showed restored strength and stiffness after height restoration in cadaveric-fractured osteoporotic vertebrae using a new device for reduction of osteoporotic vertebral fractures.
METHODS: Anterior wedge fractures (AO type A1.2) were created in 8 (4 lumbar, 4 thoracic) vertebrae by displacement eccentric external forces. In all vertebrae the amount of height reduction was 35%. After compression, 4 vertebrae were restored in height using the VJT procedure. Four vertebrae were restored in height using the IBT procedure. Posttreatment strength and stiffness of the vertebrae were determined by a compression test identical to the pretreatment compression protocol. RESULTS.: In the VJT group the post-restoration strength was 81% +/- 13% of the original strength and in the IBT group it was 96% +/- 32%. The post-restoration stiffness in the VJT group was 61% +/- 42% of the original stiffness and in the IBT group 76% +/- 62% of the original stiffness. The vertebrae in the VJT group were restored to 101% +/- 2% of their original height whereas this was 104% +/- 14% in the IBT group. In this study, no cases of cement leakage were found. No cases of damaging of the end plates, new fractures or perforations were seen in both groups. The mean amount of cement inserted for the VJT group was 3.6 +/- 0.9 cm and for the IBT group 5.9 +/- 0.8 cm.
CONCLUSION: Both kyphoplasty procedures were able to restore height in this in vitro study, while strength and stiffness were partially restored, with no significant differences. In this study on average significant less cement was used in the VJT procedure. No complications were noted in both groups. This new end plate-to-end plate laminar augmentation technique may be of clinical advantage.

Entities:  

Mesh:

Year:  2009        PMID: 19680089     DOI: 10.1097/BRS.0b013e3181b1fed8

Source DB:  PubMed          Journal:  Spine (Phila Pa 1976)        ISSN: 0362-2436            Impact factor:   3.468


  4 in total

1.  Jack vertebral dilator kyphoplasty for treatment of osteoporotic vertebral compression fractures.

Authors:  Dapeng Li; Yonghui Huang; Huilin Yang; Qi Chen; Taicun Sun; Yan Wu; Xuefeng Li
Journal:  Eur J Orthop Surg Traumatol       Date:  2012-11-11

2.  Three generations of treatments for osteoporotic vertebral fractures: what is the evidence?

Authors:  Luigi Aurelio Nasto; Eugenio Jannelli; Valerio Cipolloni; Luca Piccone; Alessandro Cattolico; Alessandro Santagada; Charlotte Pripp; Alfredo Schiavone Panni; Enrico Pola
Journal:  Orthop Rev (Pavia)       Date:  2022-10-13

Review 3.  A 20-Year Review of Biomechanical Experimental Studies on Spine Implants Used for Percutaneous Surgical Repair of Vertebral Compression Fractures.

Authors:  Sairam Gajavelli; Aaron Gee; Z Shaghayegh Bagheri; Emil H Schemitsch; Christopher S Bailey; Parham Rasoulinejad; Radovan Zdero
Journal:  Biomed Res Int       Date:  2022-09-21       Impact factor: 3.246

4.  Evaluation of surgical outcome of Jack vertebral dilator kyphoplasty for osteoporotic vertebral compression fracture-clinical experience of 218 cases.

Authors:  Jin Fan; Yimin Shen; Ning Zhang; Yongxin Ren; Weihua Cai; Lipeng Yu; Naiqing Wu; Guoyong Yin
Journal:  J Orthop Surg Res       Date:  2016-04-30       Impact factor: 2.359

  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.