Literature DB >> 19467040

Effect of filling technique and root canal area on the percentage of gutta-percha in laterally compacted root fillings.

E M Souza1, M-K Wu, L W van der Sluis, R T Leonardo, I Bonetti-Filho, P R Wesselink.   

Abstract

AIM: To determine the influence of filling technique and root canal area on the percentage of gutta-percha (PGP) in laterally compacted root fillings.
METHODOLOGY: Sixty extracted canine teeth were accessed and the root canals instrumented to the same size. They were then divided in three groups and filled with laterally compacted gutta-percha cones and AH Plus using different techniques. A variation of cold lateral compaction using a sequence of spreaders prior to accessory cone placement was compared to two commonly-used techniques. Twenty additional canines with prepared root canals were used as negative controls in which gutta-percha was introduced into the canals but no compaction applied. The roots were sectioned horizontally at 3 and 6 mm from the apex and micro-photographs taken. Using software, the area of the canals and gutta-percha at each level were measured and PGP calculated. A Multivariate analysis was used to determine the variables influencing PGP. A linear regression test was used to verify the variation in PGP explained by canal area.
RESULTS: At each level the largest canal was two to three times wider than the smallest. Canal area significantly influenced the PGP at both levels (P < 0.05), however, the variation in PGP was only partially explained by canal area (r(2) = 0.154, 6 mm; r(2) = 0.119, 3 mm). The PGP at the 3 mm level was lower than at 6 mm (P = 0.003). The spreader-sequence technique achieved a higher PGP than the other two techniques (P = 0.00002). The control group had the lowest area of GP.
CONCLUSIONS: Variations in root canal filling technique and canal area influenced the percentage of gutta-percha of laterally compacted root fillings. The percentage of gutta-percha was lower at the 3 mm level compared to the 6 mm level.

Entities:  

Mesh:

Substances:

Year:  2009        PMID: 19467040     DOI: 10.1111/j.1365-2591.2009.01575.x

Source DB:  PubMed          Journal:  Int Endod J        ISSN: 0143-2885            Impact factor:   5.264


  6 in total

1.  An ex vivo comparison of the push-out bond strength of a new endodontic filling system (Smartseal) and various gutta-percha filling techniques.

Authors:  Nikolaos Economides; Christos Gogos; Konstantinos Kodonas; Charilaos Beltes; Ioannis Kolokouris
Journal:  Odontology       Date:  2011-09-24       Impact factor: 2.634

2.  Apical filling characteristics of carrier-based techniques vs. single cone technique in curved root canals.

Authors:  K W Neuhaus; A Schick; A Lussi
Journal:  Clin Oral Investig       Date:  2015-11-27       Impact factor: 3.573

3.  A comparative evaluation of gutta-percha filled areas in curved root canals obturated with different techniques.

Authors:  Edgar Schäfer; Birthe Nelius; Sebastian Bürklein
Journal:  Clin Oral Investig       Date:  2011-01-20       Impact factor: 3.573

4.  3D analyses of interface voids in root canals filled with different sealer materials in combination with warm gutta-percha technique.

Authors:  M Wolf; K Küpper; S Reimann; C Bourauel; M Frentzen
Journal:  Clin Oral Investig       Date:  2013-03-24       Impact factor: 3.573

5.  Technical quality of a matching-taper single-cone filling technique following rotary instrumentation compared with lateral compaction after manual preparation: a retrospective study.

Authors:  R Krug; G Krastl; M Jahreis
Journal:  Clin Oral Investig       Date:  2016-08-13       Impact factor: 3.573

6.  Effect of spreader size on microleakage of roots filled with cold lateral compaction technique.

Authors:  Tugba Turk; Beyser Piskin; Hasan Orucoglu; Berdan Aydin
Journal:  Eur J Dent       Date:  2015 Jul-Sep
  6 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.