Effect of plasticizer type and amount on hydroxypropyl methylcellulose-beeswax edible film properties and postharvest quality of coated plums (cv. Angeleno).

The effect of the composition of hydroxypropyl methylcellulose (HPMC)-beeswax (BW) edible coatings on stand-alone film properties and on postharvest quality of coated 'Angeleno' plums was studied. Glycerol (G) and mannitol (M) were tested as plasticizers at two different plasticizer/HPMC ratios (100:1 and 300:1 molar basis). BW content was 20 or 40% (dry basis). An increase in G content increased film flexibility and vapor permeability (WVP), whereas an increase in M content enhanced film brittleness without affecting WVP. An increase in BW content reduced film flexibility and reduced WVP of only G-plasticized films. Coatings reduced plum softening and bleeding, but were not effective in reducing plum weight loss. At low plasticizer content, coatings reduced texture loss effectively. Low BW also lowered plum bleeding. Plasticizer type affected only ethanol and acetaldehyde contents without affecting the remaining quality parameters. Therefore, HPMC-BW coatings have the potential to extend the shelf life of plums. However, this effect depends on coating composition. Differences between coating and film performance indicate that data from stand-alone films may be used as a preliminary screening, but coating performance should be analyzed on coated fruit.