Literature DB >> 18505216

Clinical evaluation of the soft-start (pulse-delay) polymerization technique in Class I and II composite restorations.

Daniel C N Chan1, W D Browning, K B Frazier, M G Brackett.   

Abstract

UNLABELLED: The polymerization shrinkage of resin composites may affect restoration quality. A double blind, randomized clinical trial was carried out to compare two curing techniques-Soft-Start (SS) and the plasma arc curing light (PAC). The hypothesis that, delaying the gel point (with SS) improves marginal seal, was tested at alpha = 0.05. Also, this report includes two-week, three-month, one-year and two-year results for post-op sensitivity. Twenty informed participants, each needing two Class II and/or complex Class I restorations, gave written consent. All the teeth were trans-illuminated to rule out pre-op crack lines before restoration placement. Fifty Z100-Single Bond restorations (25/SS and 25/PAC) were placed under rubber dam. Protocols: PAC (Control)-incremental curing < 2.0 mm, 2000 mW/cm2 for 10 seconds for all layers, SS (Treatment)-incremental curing <2.0 mm, 600 mW/cm2 for 20 seconds, except the final layer or enamel replacement increment, which was cured as follows-(mW/cm2/time) 200/3 seconds, wait 3 minutes; 200/3 seconds, wait 5 minutes; 600/20 seconds from multiple angles. Sensitivity to a standardized cold stimulus was performed preoperatively at 2 weeks and at 3, 12 and 24 months. Patients rated their sensitivity after stimulus by means of a Visual Analog Scale (VAS). In addition, two independent, calibrated investigators evaluated the restorations clinically at each appointment. There were no significant differences in VAS scores between the two groups at any appointment period (two-way ANOVA; p > 0.05). Several conditions were defined as indicating marginal stress before the start of the trial. At 24 months, there was no significant difference between the SS and PAC groups.
CONCLUSION: Within the limitations of this study, Class I and II restorations placed with a SS technique did not show significant changes in post-op sensitivity or decreased signs of marginal stress.

Entities:  

Mesh:

Substances:

Year:  2008        PMID: 18505216     DOI: 10.2341/07-120

Source DB:  PubMed          Journal:  Oper Dent        ISSN: 0361-7734            Impact factor:   2.440


  6 in total

Review 1.  Compliance of randomized controlled trials in posterior restorations with the CONSORT statement: a systematic review of methodology.

Authors:  Márcia Rezende; Ana Cristina Rodrigues Martins; Jadson Araújo da Silva; Alessandra Reis; Juliana Larocca de Geus
Journal:  Clin Oral Investig       Date:  2021-09-30       Impact factor: 3.606

2.  Effects of different light curing units/modes on the microleakage of flowable composite resins.

Authors:  A Ruya Yazici; Cigdem Celik; Berrin Dayangac; Gul Ozgunaltay
Journal:  Eur J Dent       Date:  2008-10

3.  Postoperative sensitivity in Class V composite restorations: Comparing soft start vs. constant curing modes of LED.

Authors:  Fahad Umer; Frahan Raza Khan
Journal:  J Conserv Dent       Date:  2011-01

4.  Effect of C-factor and LED Curing Mode on Microleakage of Class V Resin Composite Restorations.

Authors:  Qasem Diefallah Alomari; Kefah Barrieshi-Nusair; Mohammad Ali
Journal:  Eur J Dent       Date:  2011-08

5.  Effect of thermocycling and varying polymerization techniques on the restorative interface of class V cavities restored with different composite resin systems.

Authors:  Jefferson-Ricardo Pereira; Lindomar-Corrêa Júnior; Marcus-Vinicius-Reis Só; Newton-Fahl Júnior
Journal:  J Clin Exp Dent       Date:  2017-03-01

6.  Effect of modulated photoactivation of bulkfill composite on microleakage in fluorosed and nonfluorosed teeth: A confocal laser scanning microscopy study.

Authors:  J N Krishna Muppalla; V Harikumar; P Sarathchandra; S Jayaprada Reddy; P Rajani
Journal:  J Conserv Dent       Date:  2020-11-05
  6 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.