Literature DB >> 18500831

Hydrophilic alcohol ethoxylates as efficiency boosters for microemulsions.

Christian Frank1, Henrich Frielinghaus, Jürgen Allgaier, Dieter Richter.   

Abstract

Highly amphiphilic polyalkane-PEO diblock copolymers drastically increase the solubilization capacity of surfactants in microemulsions if they are used in small quantities as additive to the surfactant. This effect goes along with an additional reduction of the already very low interfacial tension between water and oil. Lamellar phases, which usually develop when the surfactant becomes more efficient, are suppressed to a large extent. In this work we use another type of additive, namely hydrophilic alcohol ethoxylates. These amphiphiles are identical with the previously used block copolymers with respect to the hydrophilic moiety. However, they contain only small hydrocarbon groups ranging from C8 to C18. A typical example from the hydrophilic alcohol ethoxylates is C12E100. Both additive types increase surfactant efficiency equally with respect to mass fraction in the mixture. Because the alcohol ethoxylate additives decorate the surfactant film only on the aqueous side, they influence the curvature of the surfactant membrane or, in other words, the temperature behavior of the microemulsion. Together with nonionic surfactants, however, the shift of the one-phase region to higher temperatures is only a few degrees Celsius. Just as with the polyalkane-PEO block copolymers, the hydrophilic alcohol ethoxylates suppress lamellar phases. This behavior is especially pronounced if the hydrophobic groups are small or the PEO chains are long. We found that hydrophobic units as short as C 8 are sufficient to largely anchor the PEO chains at the interface. If C12 or C18 hydrocarbon unit are used instead, the PEO chains are fully interfacially active, even if the hydrophilic chain contains up to about 500 EO units. We applied the new additives in bicontinuous and in droplet microemulsions and used nonionic, as well as ionic, surfactants, namely C10E4 and AOT. In contrast to polyalkane-PEO blockcopolymers the new additives are easy to synthesize and are commercially available. Therefore, they might be interesting in applications.

Entities:  

Year:  2008        PMID: 18500831     DOI: 10.1021/la800360m

Source DB:  PubMed          Journal:  Langmuir        ISSN: 0743-7463            Impact factor:   3.882


  2 in total

1.  Curling and local shape changes of red blood cell membranes driven by cytoskeletal reorganization.

Authors:  Doron Kabaso; Roie Shlomovitz; Thorsten Auth; Virgilio L Lew; Nir S Gov
Journal:  Biophys J       Date:  2010-08-04       Impact factor: 4.033

2.  How to Attain an Ultralow Interfacial Tension and a Three-Phase Behavior with a Surfactant Formulation for Enhanced Oil Recovery: A Review. Part 2. Performance Improvement Trends from Winsor's Premise to Currently Proposed Inter- and Intra-Molecular Mixtures.

Authors:  Jean-Louis Salager; Ana M Forgiarini; Laura Márquez; Lisbeth Manchego; Johnny Bullón
Journal:  J Surfactants Deterg       Date:  2013-05-03       Impact factor: 1.902

  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.