Bond strength of adhesively luted ceramic discs to different core materials.

The purpose of this in vitro study was to compare the shear bond strengths of resin, glass-ionomer, and ceramic-based core materials to all ceramic discs. Five core materials (Core max, Sankin; Clearfil AP-X, Kuraray; Empress Cosmo, Ivoclar-Vivadent; Photocore, Kuraray; Dyract Extra, Dentsply) were prepared as discs 10 mm in diameter and 2 mm in height according to the manufacturer's instructions. Ten disc specimens per group were prepared, and dentin served as the control. All resin specimens were embedded in autopolymerizing acrylic resin, with one surface facing up. All ceramic discs (IPS Empress I, Ivoclar-Vivadent) 3 mm in diameter and 2 mm in height were prepared and bonded to core specimens with a dual-curing luting resin cement (Variolink II, Vivadent). Specimens were stored in distilled water at 37 degrees C. Shear bond strength of each sample was measured after 24 h using a universal testing machine at a crosshead speed of 0.5 mm/min. The data were analyzed with one-way analysis of variance and Tukey HSD tests (alpha = 0.05). Shear bond strength varied significantly depending on the core material used (p < 0.05). Clearfil AP-X and Photocore showed the highest shear bond strength value while Empress Cosmo provided the lowest (p < 0.05). There were no statistically significant differences among Clearfil AP-X, Photocore, and Core-Max (p > 0.05). And also there were no statistically significant differences between Dyract Extra and the control group (p > 0.05). In vitro shear bond strengths of ceramic discs bonded to resin-based core materials showed higher bond strength values than ceramic-based core material.