Literature DB >> 18351731

Novel iron(III) porphyrazine complex. Complex speciation and reactions with NO and H2O2.

Alexander Theodoridis1, Joachim Maigut, Ralph Puchta, Evgeny V Kudrik, Rudi van Eldik.   

Abstract

The complex [iron(III) (octaphenylsulfonato)porphyrazine] (5-), Fe (III)(Pz), was synthesized. The p K a values of the axially coordinated water molecules were determined spectrophotometrically and found to be p K a 1 = 7.50 +/- 0.02 and p K a 2 = 11.16 +/- 0.06. The water exchange reaction studied by (17)O NMR as a function of the pH was fast at pH = 1, k ex = (9.8 +/- 0.6) x 10 (6) s (-1) at 25 degrees C, and too fast to be measured at pH = 10, whereas at pH = 13, no water exchange reaction occurred. The equilibrium between mono- and diaqua Fe (III)(Pz) complexes was studied at acidic pH as a function of the temperature and pressure. Complex-formation equilibria with different nucleophiles (Br (-) and pyrazole) were studied in order to distinguish between a five- (in the case of Br (-)) or six-coordinate (in the case of pyrazole) iron(III) center. The kinetics of the reaction of Fe (III)(Pz) with NO was studied as a model ligand substitution reaction at various pH values. The mechanism observed is analogous to the one observed for iron(III) porphyrins and follows an I d mechanism. The product is (Pz)Fe (II)NO (+), and subsequent reductive nitrosylation usually takes place when other nucleophiles like OH (-) or buffer ions are present in solution. Fe (III)(Pz) also activates hydrogen peroxide. Kinetic data for the direct reaction of hydrogen peroxide with the complex clearly indicate the occurrence of more than one reaction step. Kinetic data for the catalytic decomposition of the dye Orange II by H 2O 2 in the presence of Fe (III)(Pz) imply that a catalytic oxidation cycle is initiated. The peroxide molecule first coordinates to the iron(III) center to produce the active catalytic species, which immediately oxidizes the substrate. The influence of the catalyst, oxidant, and substrate concentrations on the reaction rate was studied in detail as a function of the pH. The rate increases with increasing catalyst and peroxide concentrations but decreases with increasing substrate concentration. At low pH, the oxidation of the substrate is not complete because of catalyst decomposition. The observed kinetic traces at pH = 10 and 12 for the catalytic cycle could be simulated on the basis of the obtained kinetic data and the proposed reaction cycle. The experimental results are in good agreement with the simulated ones.

Entities:  

Mesh:

Substances:

Year:  2008        PMID: 18351731     DOI: 10.1021/ic702041g

Source DB:  PubMed          Journal:  Inorg Chem        ISSN: 0020-1669            Impact factor:   5.165


  3 in total

1.  Designing green oxidation catalysts for purifying environmental waters.

Authors:  W Chadwick Ellis; Camly T Tran; Riddhi Roy; Marte Rusten; Andreas Fischer; Alexander D Ryabov; Bruce Blumberg; Terrence J Collins
Journal:  J Am Chem Soc       Date:  2010-07-21       Impact factor: 15.419

2.  Activation of Dioxygen by a TAML Activator in Reverse Micelles: Characterization of an Fe(III)Fe(IV) Dimer and Associated Catalytic Chemistry.

Authors:  Liang L Tang; William A Gunderson; Andrew C Weitz; Michael P Hendrich; Alexander D Ryabov; Terrence J Collins
Journal:  J Am Chem Soc       Date:  2015-07-23       Impact factor: 15.419

3.  A "Beheaded" TAML Activator: A Compromised Catalyst that Emphasizes the Linearity between Catalytic Activity and pKa.

Authors:  Matthew R Mills; Andrew C Weitz; David Z Zhang; Michael P Hendrich; Alexander D Ryabov; Terrence J Collins
Journal:  Inorg Chem       Date:  2016-11-11       Impact factor: 5.165

  3 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.