OBJECTIVES: The aim of this study was to test the hypothesis that the residual stresses in a zirconia-based bilayer dental composite system can be tailored through heat treatment above and below the glass transition temperature of glass veneers. METHODS: Ceramic bilayer disc specimens were prepared from a zirconia core and a glass veneer. Each bilayer ceramic group was heat treated 40 degrees C below, 20 degrees C and 40 degrees C above and at the glass transition temperature of the glass veneer, and cooled using a fast or a slow cooling rate. Specimens were tested for flexure strength using a biaxial bending fixture. Residual stresses were calculated using a fracture mechanics approach. RESULTS: Heat treatments produced significant differences (p < or =0.05) between the mean flexural strengths of the heat treatment groups when the specimens were cooled using a fast cooling rate. However, there was not a significant difference (p >0.05) between the mean flexural strengths of the heat treatment groups when a slow cooling rate was used. Fractures initiated from the veneer surfaces of the specimens. SIGNIFICANCE: Heat treatment above and below the glass transition temperature of the veneer layer, and the cooling rate have a significant effect on the flexural strength of the bilayer ceramic laminates. The existence of residual compressive stress is the most likely reason for the observed strength increases. Residual stresses can be modified using the elastic-viscoelastic relaxation behavior of a glass veneer.
OBJECTIVES: The aim of this study was to test the hypothesis that the residual stresses in a zirconia-based bilayer dental composite system can be tailored through heat treatment above and below the glass transition temperature of glass veneers. METHODS: Ceramic bilayer disc specimens were prepared from a zirconia core and a glass veneer. Each bilayer ceramic group was heat treated 40 degrees C below, 20 degrees C and 40 degrees C above and at the glass transition temperature of the glass veneer, and cooled using a fast or a slow cooling rate. Specimens were tested for flexure strength using a biaxial bending fixture. Residual stresses were calculated using a fracture mechanics approach. RESULTS: Heat treatments produced significant differences (p < or =0.05) between the mean flexural strengths of the heat treatment groups when the specimens were cooled using a fast cooling rate. However, there was not a significant difference (p >0.05) between the mean flexural strengths of the heat treatment groups when a slow cooling rate was used. Fractures initiated from the veneer surfaces of the specimens. SIGNIFICANCE: Heat treatment above and below the glass transition temperature of the veneer layer, and the cooling rate have a significant effect on the flexural strength of the bilayer ceramic laminates. The existence of residual compressive stress is the most likely reason for the observed strength increases. Residual stresses can be modified using the elastic-viscoelastic relaxation behavior of a glass veneer.
Authors: Camila da Silva Rodrigues; Iana Lamadrid Aurélio; Marina da Rosa Kaizer; Yu Zhang; Liliana Gressler May Journal: Dent Mater Date: 2019-03-04 Impact factor: 5.304
Authors: Camila da Silva Rodrigues; Iana Lamadrid Aurélio; Sara Fraga; Marina da Rosa Kaizer; Yu Zhang; Liliana Gressler May Journal: Dent Mater Date: 2021-04-15 Impact factor: 5.687
Authors: Gergo Mitov; Yana Anastassova-Yoshida; Frank Phillip Nothdurft; Constantin von See; Peter Pospiech Journal: J Adv Prosthodont Date: 2016-02-23 Impact factor: 1.904