Literature DB >> 18302188

Skating and diving: Changes in functional morphology of the setal and microtrichial cover during ontogenesis in Aquarius paludum fabricius (Heteroptera, Gerridae).

P J Perez Goodwyn1, D Voigt, K Fujisaki.   

Abstract

We examined the morphology of setae and microtrichia in Aquarius paludum during larval development using a scanning electron microscope. We then conducted immersion experiments with larvae and adults in oxygenated and deoxygenated water. The adult water strider body is covered by a pilose double layer consisting of upper long setae (30-80 microm) and lower filiform microtrichia (5-9 microm). Only setae are present on the legs. Microtrichia on the larval body are very short: 0.5-0.6 microm in first and second instars, and 0.8-1.7 microm in third to fifth instars. Larval body setae are approximately as long as those of adults (25-50 microm), but are much less dense at 1,800-5,750 setae per mm(2) versus 15,000-20,000 setae per mm(2) in adults. The density of setae on the legs remains relatively constant throughout development (larvae: 15,000-20,000 setae per mm(2); adults: 20,000-26,000 setae per mm(2)). Immersion experiments demonstrated that young instars may use cuticular respiration. First- and second-instar larvae survived underwater for several hours without a visible air supply, although they did not survive in deoxygenated water. We posit that the short body microtrichia have a waterproofing function in larvae, whereas they create a compressible air bubble in adults. In adults, waterproofing is accomplished by the setae. The density and length of setae on the legs of larvae was nearly the same as that on the body and legs of adults and is presumably optimized for waterproofing. Thus, a change in morphometrical parameters can result in a large functional change in the same structure. We discuss this interpretation in both ecological and physiological contexts. 2008 Wiley-Liss, Inc

Entities:  

Mesh:

Substances:

Year:  2008        PMID: 18302188     DOI: 10.1002/jmor.10619

Source DB:  PubMed          Journal:  J Morphol        ISSN: 0022-2887            Impact factor:   1.804


  6 in total

1.  Physical conditions for trapping air by a microtrichia-covered insect cuticle during temporary submersion.

Authors:  Dietrich Neumann; Dietrich Woermann
Journal:  Naturwissenschaften       Date:  2009-05-13

Review 2.  Interfacial phenomena of water striders on water surfaces: a review from biology to biomechanics.

Authors:  Jing-Ze Ma; Hong-Yu Lu; Xiao-Song Li; Yu Tian
Journal:  Zool Res       Date:  2020-05-18

3.  Robust non-wetting PTFE surfaces by femtosecond laser machining.

Authors:  Fang Liang; Jorge Lehr; Lisa Danielczak; Richard Leask; Anne-Marie Kietzig
Journal:  Int J Mol Sci       Date:  2014-08-08       Impact factor: 5.923

4.  Avoidance, escape and microstructural adaptations of the tea green leafhopper to water droplets.

Authors:  Meizhen Lin; Liette Vasseur; Guang Yang; Geoff M Gurr; Minsheng You
Journal:  Sci Rep       Date:  2016-11-15       Impact factor: 4.379

5.  Identification of Nanopillars on the Cuticle of the Aquatic Larvae of the Drone Fly (Diptera: Syrphidae).

Authors:  Matthew J Hayes; Timothy P Levine; Roger H Wilson
Journal:  J Insect Sci       Date:  2016-03-30       Impact factor: 1.857

6.  Gene regulatory network architecture in different developmental contexts influences the genetic basis of morphological evolution.

Authors:  Sebastian Kittelmann; Alexandra D Buffry; Franziska A Franke; Isabel Almudi; Marianne Yoth; Gonzalo Sabaris; Juan Pablo Couso; Maria D S Nunes; Nicolás Frankel; José Luis Gómez-Skarmeta; Jose Pueyo-Marques; Saad Arif; Alistair P McGregor
Journal:  PLoS Genet       Date:  2018-05-03       Impact factor: 5.917

  6 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.