Optimization of Bomaplex Red CR-L dye removal from aqueous solution by electrocoagulation using aluminum electrodes.

In this paper, Taguchi method was applied to determine the optimum dye removal from aqueous solution by electrocoagulation using aluminum electrodes. An orthogonal array (OA(16)) experimental design that allows to investigate the simultaneous variations of five parameters (initial dye concentration, initial pH of the solution, supporting electrolyte concentration, supporting electrolyte type and current density) having four levels was employed to evaluate the effects of experimental parameters. Performance measure analysis was followed by performing a variance analysis, in order to determine the optimum levels and relative magnitude of the effect of parameters. Because the desired characteristic for response has been maximum decolorization, Taguchi's 'the larger the better' performance formula was used. While the optimum conditions were found to be initial dye concentration of 100 mg/L, initial pH of the solution of 3, supporting electrolyte concentration of 0.0 mM, supporting electrolyte type of CaCl(2) and current density of 0.50 mA/cm(2). Under these optimum conditions, energy consumption is 0.607 kWh/kg dye, when the system evaluated also based on the energy consumptions it can be said that optimum conditions should be modified as follows: supporting electrolyte concentration of 2.5 mM; supporting electrolyte type NaCl, for 100 mg/L initial dye concentration; initial pH of the solution of 3; current density of 0.50 mA/cm(2).