Literature DB >> 17427828

Restoration interface microleakage using one total-etch and three self-etch adhesives.

S Deliperi1, D N Bardwell, C Wegley.   

Abstract

This study evaluated the efficacy of a total-etch and three self-etch adhesives in reducing microleakage after three months water storage and thermocycling. Thirty freshly extracted caries-free human premolars and molars were used. Class V standardized preparations were performed on the facial and lingual surfaces, with the gingival margin placed 1 mm below the CEJ. The teeth were randomly divided into four groups; Group I: Xeno III one-step self-etch adhesive (Dentsply/Caulk), Group II: Prime & Bond NT total-etch adhesive (Dentsply/Caulk), Group III: i-Bond one-step self-etch adhesive (Heraeus Kulzer) and Group IV: Clearfil SE Bond two-step self-etch adhesive (Kuraray Medical). The teeth were restored using 2 mm increments of shade A2 resin composite (Esthet-X, Dentsply/Caulk). Each layer was cured using the Spectrum 800 curing light (Dentsply/Caulk) for 20 seconds at 600mW/cm2. The teeth were stored in distilled water for 90 days. Samples were thermocycled 500x between 5 degrees C and 55 degrees C with a dwell time of 30 seconds, then placed in a 0.5% methylene blue dye solution for 24 hours at 37 degrees C. Samples were sectioned longitudinally and evaluated for microleakage at the occlusal and gingival margins under a stereomicroscope at 20x magnification. Dye penetration was scored: 0 = no penetration; 1 = partial dye penetration along the occlusal or gingival wall; 2 = dye penetration along the occlusal or gingival wall; 3 = dye penetration to and along the axial wall. A Mann-Whitney test was used to demonstrate significantly more dye penetration in Group III than in the other groups at both the occlusal and gingival scores (p < 0.0001). When comparing the occlusal and gingival scores for each group, the Wilcoxon Rank test showed no significant difference in dye penetration for Xeno III (p > 0.05), Prime & Bond NT (p = 0.059) and I Bond (p = 0.083), and Clearfil SE Bond yielded more dye penetration at the occlusal than at the gingival wall (p = 0.001).

Entities:  

Mesh:

Substances:

Year:  2007        PMID: 17427828     DOI: 10.2341/06-54

Source DB:  PubMed          Journal:  Oper Dent        ISSN: 0361-7734            Impact factor:   2.440


  17 in total

1.  Analysis of micro-shear bond strength of self-etch adhesive systems with dentine: An in vitro study.

Authors:  Vijay Kumar Shakya; Rajeev Kumar Singh; Anjani Kumar Pathak; Balendra Pratap Singh; Anil Chandra; Ramesh Bharti; Rakesh Kumar Yadav
Journal:  J Oral Biol Craniofac Res       Date:  2015-08-21

Review 2.  Classification review of dental adhesive systems: from the IV generation to the universal type.

Authors:  Eshrak Sofan; Afrah Sofan; Gaspare Palaia; Gianluca Tenore; Umberto Romeo; Guido Migliau
Journal:  Ann Stomatol (Roma)       Date:  2017-07-03

Review 3.  Cement selection criteria for full coverage restorations: A comprehensive review of literature.

Authors:  Safoura Ghodsi; Sarah Arzani; Mina Shekarian; MohammadMostafa Aghamohseni
Journal:  J Clin Exp Dent       Date:  2021-11-01

4.  Microleakage of class-v composite restorations with different bonding systems on fluorosed teeth.

Authors:  Cigdem Küçükeşmen; Hayriye Sönmez
Journal:  Eur J Dent       Date:  2008-01

5.  Efficacy of hydrophobic layer on sealing ability of dentin adhesive systems in class v composite resin restorations.

Authors:  Fatemeh Maleknejad; Saied Mostafa Moazzami; Elham Baradaran Nasseri; Ehsan Baradaran Nasseri
Journal:  J Dent Res Dent Clin Dent Prospects       Date:  2011-03-18

6.  Comparative evaluation of microleakage of fifth, sixth, and seventh generation dentin bonding agents: An in vitro study.

Authors:  S Vinay; Vasundhara Shivanna
Journal:  J Conserv Dent       Date:  2010-07

7.  Effect of thermal and mechanical loading on marginal adaptation and microtensile bond strength of a self-etching adhesive with caries-affected dentin.

Authors:  Vivek Aggarwal; Mamta Singla; Sanjay Miglani
Journal:  J Conserv Dent       Date:  2011-01

8.  Bonding all-ceramic restorations with two resins cement techniques: a clinical report of three-year follow-up.

Authors:  Rodolfo Bruniera Anchieta; Eduardo Passos Rocha; Erika Oliveira de Almeida; Amilcar Chagas Freitas Junior; Ana Paula Martini
Journal:  Eur J Dent       Date:  2011-08

9.  The effect of cutting efficacy of diamond burs on microleakage of class v resin composite restorations using total etch and self etch adhesive systems.

Authors:  M R Malekipour; F Shirani; S Tahmourespour
Journal:  J Dent (Tehran)       Date:  2010-09-30

10.  Effects of different antibacterial disinfectants on microleakage of bulk-fill composite bonded to different tooth structures.

Authors:  Mohammed Bin-Shuwaish; Alhanouf AlHussaini; Lina AlHudaithy; Shamma AlDukhiel; Abdullah AlJamhan; Ali Alrahlah
Journal:  BMC Oral Health       Date:  2021-07-16       Impact factor: 2.757

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.