OBJECTIVES: This study evaluated new bone formation at the midpalatal suture after surgically assisted rapid maxillary expansion (SARME) by optical density analysis. METHODS: The study population consisted of 18 patients, 10 males and 8 females. All patients presented maxillary atresia with posterior crossbite and were submitted to SARME. Maxillary occlusal radiographs were taken at three stages (before SARME, immediately after SARME and after 3 months). Three patients did not attend the session at the 3-month period for achievement of the occlusal radiography and thus were excluded, leading to a final sample of 15 patients. Two regions were selected and analysed at each stage. Region A measured 8 x 1 mm(2) and was located 1.2 cm from the tangent to the maxillary central incisors at the region of the midpalatal suture. Region B measured 5 x 9 mm(2) and was located 4.3 cm from the tangent to the maxillary central incisors at the region of the midpalatal suture. An aluminium scale (step wedge) with eight steps varying from 1 mm to 8 mm was adapted at the end of the films. Radiographs were taken on a Spectro 70X machine (Dabi Atlante, Ribeirão Preto, Brazil) set at 70 kVp and 10 mA with an exposure time of 1.0 s. Radiographs were scanned using a Power Look 1000 scanner (Umax, Taiwan, China) and a computer Dimension E510 (Dell Computer, Taiwan, China). Optical density analysis was performed after digitization of radiographs using the software Image Tool (UTHSCSA, San Antonio, TX). RESULTS: Statistical analysis of region A revealed statistically significant differences between Stages I and II (P=0.0001), Stages II and III (P=0.0001) and Stages I and III (P=0.0003). In region B, statistically significant differences were observed between Stages I and II, I and III and II and III (P=0.0018, P=0.0003 and P=0.0003, respectively). CONCLUSIONS: Optical density analysis improves post-treatment control of SARME procedures by surgeons and orthodontists. After 3 months, new bone formation at the midpalatal suture is not complete.
OBJECTIVES: This study evaluated new bone formation at the midpalatal suture after surgically assisted rapid maxillary expansion (SARME) by optical density analysis. METHODS: The study population consisted of 18 patients, 10 males and 8 females. All patients presented maxillary atresia with posterior crossbite and were submitted to SARME. Maxillary occlusal radiographs were taken at three stages (before SARME, immediately after SARME and after 3 months). Three patients did not attend the session at the 3-month period for achievement of the occlusal radiography and thus were excluded, leading to a final sample of 15 patients. Two regions were selected and analysed at each stage. Region A measured 8 x 1 mm(2) and was located 1.2 cm from the tangent to the maxillary central incisors at the region of the midpalatal suture. Region B measured 5 x 9 mm(2) and was located 4.3 cm from the tangent to the maxillary central incisors at the region of the midpalatal suture. An aluminium scale (step wedge) with eight steps varying from 1 mm to 8 mm was adapted at the end of the films. Radiographs were taken on a Spectro 70X machine (Dabi Atlante, Ribeirão Preto, Brazil) set at 70 kVp and 10 mA with an exposure time of 1.0 s. Radiographs were scanned using a Power Look 1000 scanner (Umax, Taiwan, China) and a computer Dimension E510 (Dell Computer, Taiwan, China). Optical density analysis was performed after digitization of radiographs using the software Image Tool (UTHSCSA, San Antonio, TX). RESULTS: Statistical analysis of region A revealed statistically significant differences between Stages I and II (P=0.0001), Stages II and III (P=0.0001) and Stages I and III (P=0.0003). In region B, statistically significant differences were observed between Stages I and II, I and III and II and III (P=0.0018, P=0.0003 and P=0.0003, respectively). CONCLUSIONS: Optical density analysis improves post-treatment control of SARME procedures by surgeons and orthodontists. After 3 months, new bone formation at the midpalatal suture is not complete.
Authors: Fabíola Nogueira Holanda Ferreira; Juliana Oliveira Gondim; José Jeová Siebra Moreira Neto; Pedro Cesar Fernandes Dos Santos; Karina Matthes de Freitas Pontes; Lúcio Mitsuo Kurita; Maria Walderez Andrade de Araújo Journal: Lasers Med Sci Date: 2016-04-07 Impact factor: 3.161