PURPOSE: To evaluate the microhardness and surface roughness of enamel and root dentin bleached with 10%, 15% and 22% carbamide peroxide agents. METHODS: 52 slabs of enamel and root dentin (6 x 3 x 2 mm) were cut from bovine incisors, ground flat and polished. According to a randomized complete block design, enamel and root dentin slabs (n = 13) were independently allocated to be bleached with one of the following carbamide peroxide-containing agents (CP): 10% (Rembrandt Bleaching Gel Plus), 15% (Rembrandt Xtra Comfort), or 22% (Rembrandt Xtra Comfort Ultra Strength). The control groups were mock-treated with artificial saliva. The bleaching procedures consisted of daily application of the agents on dental substrate surfaces for 2 hours, followed by immersion in artificial saliva for 22 hours over 21 days. Knoop microhardness and surface roughness were measured initially, on sound dental tissues, and at the postbleaching phase. RESULTS: In enamel, microhardness attained after bleaching with 10% CP and 15% CP were similar and significantly lower than that observed for the control group. Specimens bleached with CP 22% did not differ from any of the other groups tested. In root dentin, microhardness changes were indistinguishable. ANOVA showed no significant difference among treatments with respect to surface roughness.
PURPOSE: To evaluate the microhardness and surface roughness of enamel and root dentin bleached with 10%, 15% and 22% carbamide peroxide agents. METHODS: 52 slabs of enamel and root dentin (6 x 3 x 2 mm) were cut from bovine incisors, ground flat and polished. According to a randomized complete block design, enamel and root dentin slabs (n = 13) were independently allocated to be bleached with one of the following carbamide peroxide-containing agents (CP): 10% (Rembrandt Bleaching Gel Plus), 15% (Rembrandt Xtra Comfort), or 22% (Rembrandt Xtra Comfort Ultra Strength). The control groups were mock-treated with artificial saliva. The bleaching procedures consisted of daily application of the agents on dental substrate surfaces for 2 hours, followed by immersion in artificial saliva for 22 hours over 21 days. Knoop microhardness and surface roughness were measured initially, on sound dental tissues, and at the postbleaching phase. RESULTS: In enamel, microhardness attained after bleaching with 10% CP and 15% CP were similar and significantly lower than that observed for the control group. Specimens bleached with CP 22% did not differ from any of the other groups tested. In root dentin, microhardness changes were indistinguishable. ANOVA showed no significant difference among treatments with respect to surface roughness.