Image-guided vascular neurosurgery based on three-dimensional rotational angiography. Technical note.

Three-dimensional rotational angiography is capable of exquisite visualization of cerebral blood vessels and their pathophysiology. Unfortunately, images obtained using this modality typically show a small region of interest without exterior landmarks to allow patient-to-image registration, precluding their use for neuronavigation purposes. The aim of this study was to find an alternative technique to enable 3D rotational angiography-guided vascular neurosurgery. Three-dimensional rotational angiograms were obtained in an angiographic suite with direct navigation capabilities. After image acquisition, a navigated pointer was used to touch fiducial positions on the patient's head. These positions were located outside the image volume but could nevertheless be transformed into image coordinates and stored in the navigation system. Prior to surgery, the data set was transferred to the navigation system in the operating room, and the same fiducial positions were touched again to complete the patient-to-image registration. This technique was tested on a Perspex phantom representing the cerebral vascular tree and on two patients with an intracranial aneurysm. In both the phantom and patients, the neuronavigation system provided 3D images representing the vascular tree in its correct orientation, that is, the orientation seen by the neurosurgeon through the microscope. In one patient, tissue shift was clearly observed without significant changes in the orientation of the structures. Results in this study demonstrate the feasibility of using 3D rotational angiography data sets for neuronavigation purposes. Determining the benefit of this type of navigation should be the subject of future studies.