Literature DB >> 17221854

Evaluation of tunable diode laser absorption spectroscopy for in-process water vapor mass flux measurements during freeze drying.

Henning Gieseler1, William J Kessler, Michael Finson, Steven J Davis, Phillip A Mulhall, Vincent Bons, David J Debo, Michael J Pikal.   

Abstract

The goal of this work was to demonstrate the use of Tunable Diode Laser Absorption Spectroscopy (TDLAS) as a noninvasive method to continuously measure the water vapor concentration and the vapor flow velocity in the spool connecting a freeze-dryer chamber and condenser. The instantaneous measurements were used to determine the water vapor mass flow rate (g/s). The mass flow determinations provided a continuous measurement of the total amount of water removed. Full load runs of pure water at different pressure and shelf temperature settings and a 5% (w/w) mannitol product run were performed in both laboratory and pilot scale freeze dryers. The ratio of "gravimetric/TDLAS" measurements of water removed was 1.02 +/- 0.06. A theoretical heat transfer model was used to predict the mass flow rate and the model results were compared to both the gravimetric and TDLAS data. Good agreement was also observed in the "gravimetric/TDLAS" ratio for the 5% mannitol runs dried in both freeze dryers. The endpoints of primary and secondary drying for the product runs were clearly identified. Comparison of the velocity and mass flux profiles between the laboratory and pilot dryers indicated a higher restriction to mass flow for the lab scale freeze dryer. Copyright 2007 Wiley-Liss, Inc.

Entities:  

Mesh:

Substances:

Year:  2007        PMID: 17221854     DOI: 10.1002/jps.20827

Source DB:  PubMed          Journal:  J Pharm Sci        ISSN: 0022-3549            Impact factor:   3.534


  9 in total

1.  Quality by design: scale-up of freeze-drying cycles in pharmaceutical industry.

Authors:  Roberto Pisano; Davide Fissore; Antonello A Barresi; Massimo Rastelli
Journal:  AAPS PharmSciTech       Date:  2013-07-25       Impact factor: 3.246

2.  Determination of end point of primary drying in freeze-drying process control.

Authors:  Sajal M Patel; Takayuki Doen; Michael J Pikal
Journal:  AAPS PharmSciTech       Date:  2010-01-08       Impact factor: 3.246

3.  Optimization of the secondary drying step in freeze drying using TDLAS technology.

Authors:  Stefan C Schneid; Henning Gieseler; William J Kessler; Suman A Luthra; Michael J Pikal
Journal:  AAPS PharmSciTech       Date:  2011-02-26       Impact factor: 3.246

4.  Finite Element Method (FEM) Modeling of Freeze-drying: Monitoring Pharmaceutical Product Robustness During Lyophilization.

Authors:  Xiaodong Chen; Vikram Sadineni; Mita Maity; Yong Quan; Matthew Enterline; Rao V Mantri
Journal:  AAPS PharmSciTech       Date:  2015-03-20       Impact factor: 3.246

5.  Recommended Best Practices for Lyophilization Validation-2021 Part I: Process Design and Modeling.

Authors:  Feroz Jameel; Alina Alexeenko; Akhilesh Bhambhani; Gregory Sacha; Tong Zhu; Serguei Tchessalov; Lokesh Kumar; Puneet Sharma; Ehab Moussa; Lavanya Iyer; Rui Fang; Jayasree Srinivasan; Ted Tharp; Joseph Azzarella; Petr Kazarin; Mehfouz Jalal
Journal:  AAPS PharmSciTech       Date:  2021-08-18       Impact factor: 3.246

Review 6.  Pharmaceutical protein solids: Drying technology, solid-state characterization and stability.

Authors:  Yuan Chen; Tarun Tejasvi Mutukuri; Nathan E Wilson; Qi Tony Zhou
Journal:  Adv Drug Deliv Rev       Date:  2021-03-08       Impact factor: 15.470

Review 7.  Model-Based PAT for Quality Management in Pharmaceuticals Freeze-Drying: State of the Art.

Authors:  Davide Fissore
Journal:  Front Bioeng Biotechnol       Date:  2017-02-07

8.  Multi-Point Wireless Temperature Sensing System for Monitoring Pharmaceutical Lyophilization.

Authors:  Xiaofan Jiang; Tong Zhu; Tatsuhiro Kodama; Nithin Raghunathan; Alina Alexeenko; Dimitrios Peroulis
Journal:  Front Chem       Date:  2018-07-17       Impact factor: 5.221

9.  Evaluation of Microwave Vacuum Drying as an Alternative to Freeze-Drying of Biologics and Vaccines: the Power of Simple Modeling to Identify a Mechanism for Faster Drying Times Achieved with Microwave.

Authors:  Akhilesh Bhambhani; Justin Stanbro; Daniel Roth; Elizabeth Sullivan; Morrisa Jones; Robert Evans; Jeffrey Blue
Journal:  AAPS PharmSciTech       Date:  2021-01-19       Impact factor: 3.246

  9 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.