Literature DB >> 17194240

The validation of a portable force plate for measuring force-time data during jumping and landing tasks.

Mark S Walsh1, Kevin R Ford, Kyle J Bangen, Gregory D Myer, Timothy E Hewett.   

Abstract

The purpose of this study was to determine the reliability and validity of a portable force plate when analyzing jumping and landing tasks. Subjects performed 3 drop vertical jumps and 3 drop landings on both a standard strain gauge laboratory force plate and a portable force plate. In contrast to typical laboratory installed force plates, the portable 6-component force plate can be easily transported and used onsite at various training or data collection sites and incorporates Hall effect technology. The measured parameters included maximum force and time to maximum force for initial stance of the both tests, maximum takeoff force, and time to maximum takeoff force for the drop vertical jump. The Pearson correlation coefficients for the drop landing and the drop vertical jump for maximum force (r = 0.942, r = 0.940), time to maximum force (r = 0.891, r = 0.920) and for drop jump maximum jumping force (r = 0.971), and time to maximum takeoff force (r = 0.917) were all high and indicate that the force data collected by a resistor-type portable force plate provide similar measures to a standard strain-gauge laboratory force plate. Additionally, the within session reliability of the drop landing and the drop vertical jump measured by the portable force plate showed high interclass correlation coefficients for examined variables of 0.979 and 9.67 for maximum landing force and 0.917 and 0.920 for time to maximum landing force, respectively. The interclass correlation coefficients for the maximum takeoff force and time to maximum takeoff force during the drop vertical jump were 0.991 and 0.86. The results indicate the force and timing measurements from the portable force plate were both valid and reliable. Use of the portable force plate may facilitate methods of force measurement that can be applied out into the field and therefore a valuable tool for on site landing and jump force measurements in a variety of settings for large numbers of subjects.

Mesh:

Year:  2006        PMID: 17194240     DOI: 10.1519/R-18225.1

Source DB:  PubMed          Journal:  J Strength Cond Res        ISSN: 1064-8011            Impact factor:   3.775


  13 in total

1.  Reliability and validity assessment of a linear position transducer.

Authors:  Manuel V Garnacho-Castaño; Silvia López-Lastra; José L Maté-Muñoz
Journal:  J Sports Sci Med       Date:  2015-03-01       Impact factor: 2.988

2.  Reliability and Validity of the Polar V800 Sports Watch for Estimating Vertical Jump Height.

Authors:  Manuel V Garnacho-Castaño; Marcos Faundez-Zanuy; Noemí Serra-Payá; José L Maté-Muñoz; Josep López-Xarbau; Moisés Vila-Blanch
Journal:  J Sports Sci Med       Date:  2021-03-01       Impact factor: 2.988

Review 3.  A brief review of strength and ballistic assessment methodologies in sport.

Authors:  Daniel Travis McMaster; Nicholas Gill; John Cronin; Michael McGuigan
Journal:  Sports Med       Date:  2014-05       Impact factor: 11.136

4.  Reliability of the one-repetition-maximum power clean test in adolescent athletes.

Authors:  Avery D Faigenbaum; James E McFarland; Robert E Herman; Fernando Naclerio; Nicholas A Ratamess; Jie Kang; Gregory D Myer
Journal:  J Strength Cond Res       Date:  2012-02       Impact factor: 3.775

5.  Establishing Normative Values for Inter-Limb Kinetic Symmetry During Landing in Uninjured Adolescent Athletes.

Authors:  Adam W VanZile; David M Reineke; Matthew J Snyder; Daniel D Jones; Renee L Dade; Thomas G Almonroeder
Journal:  Int J Sports Phys Ther       Date:  2021-08-01

6.  Sex differences in force attenuation: a clinical assessment of single-leg hop performance on a portable force plate.

Authors:  A D Harrison; K R Ford; G D Myer; T E Hewett
Journal:  Br J Sports Med       Date:  2009-10-25       Impact factor: 13.800

7.  Mechanical Differences between Barbell and Body Optimum Power Loads in the Jump Squat Exercise.

Authors:  Irineu Loturco; Lucas A Pereira; Vinicius Zanetti; Katia Kitamura; César C Cal Abad; Ronaldo Kobal; Fabio Y Nakamura
Journal:  J Hum Kinet       Date:  2016-12-15       Impact factor: 2.193

8.  Measurement errors when estimating the vertical jump height with flight time using photocell devices: the example of Optojump.

Authors:  A Attia; W Dhahbi; A Chaouachi; J Padulo; D P Wong; K Chamari
Journal:  Biol Sport       Date:  2016-12-01       Impact factor: 2.806

9.  The reliability of vertical jump tests between the Vertec and My Jump phone application.

Authors:  Vanessa R Yingling; Dimitri A Castro; Justin T Duong; Fiorella J Malpartida; Justin R Usher; Jenny O
Journal:  PeerJ       Date:  2018-04-20       Impact factor: 2.984

10.  Portable Force Plates: A Viable and Practical Alternative to Rapidly and Accurately Monitor Elite Sprint Performance.

Authors:  Irineu Loturco; Lucas A Pereira; Ronaldo Kobal; Cesar C Cal Abad; Victor Fernandes; Rodrigo Ramirez-Campillo; Timothy Suchomel
Journal:  Sports (Basel)       Date:  2018-07-12
View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.