Literature DB >> 1662648

Pulmonary response to toner upon chronic inhalation exposure in rats.

H Muhle1, B Bellmann, O Creutzenberg, C Dasenbrock, H Ernst, R Kilpper, J C MacKenzie, P Morrow, U Mohr, S Takenaka.   

Abstract

A chronic inhalation study of a test toner was conducted by exposure of groups of F-344 rats for 6 hr/day, 5 days/week for 24 months. The test toner was a special Xerox 9000 type xerographic toner, enriched in respirable-sized particles compared to commercial toner, such that it was about 35% respirable according to the ACGIH criteria. The target test aerosol exposure concentrations were 0, 1.0 (low), 4.0 (medium), and 16.0 (high) mg/m3. Titanium dioxide (5 mg/m3) and crystalline silicon dioxide (1 mg/m3), used as negative and positive controls for fibrogenicity, were also evaluated. Inhalation of the test toner or the control materials showed no signs of overt toxicity. Body weight, clinical chemistry values, food consumption, and organ weights were normal in the toner- and TiO2-exposed groups, except for a 40% increase in lung weight in the toner high-exposure group. All of the changes in the toner-exposed groups were restricted to the lungs or associated lymph nodes. A chronic inflammatory response was evident from the bronchoalveolar lavage parameters for the toner high-exposure group. The incidence of primary lung tumors was comparable among the three toner-exposed groups and the TiO2-exposed, and air-only controls, as well as consistent with historical background levels. A mild to moderate degree of lung fibrosis was observed in 92% of the rats in the toner high-exposure group, and a minimal to mild degree of fibrosis was noted in 22% of the animals in the toner middle-exposure group. The pulmonary changes in the toner high-exposure group were smaller in magnitude than those found in the crystalline silica-exposed group. The comparative fibrogenic potency of TiO2, toner, and SiO2 was estimated to be 1:5:418 using a dosimetric model and assuming a common mechanistic basis. There were no pulmonary changes of any type at the toner low-exposure level, which is most relevant in regard to potential human exposures. The lung alterations in the toner high-exposure group are interpreted in terms of "lung overloading," a generic response of the respiratory system to saturation of its detoxification capacity. The maximum tolerated dose (MTD) criterion was met at the toner high (16 mg/m3)-exposure level.

Entities:  

Mesh:

Substances:

Year:  1991        PMID: 1662648     DOI: 10.1016/0272-0590(91)90219-t

Source DB:  PubMed          Journal:  Fundam Appl Toxicol        ISSN: 0272-0590


  20 in total

1.  Development of risk-based nanomaterial groups for occupational exposure control.

Authors:  E D Kuempel; V Castranova; C L Geraci; P A Schulte
Journal:  J Nanopart Res       Date:  2012-08-07       Impact factor: 2.253

Review 2.  Nanoparticle exposures from nano-enabled toner-based printing equipment and human health: state of science and future research needs.

Authors:  Sandra Vanessa Pirela; John Martin; Dhimiter Bello; Philip Demokritou
Journal:  Crit Rev Toxicol       Date:  2017-05-19       Impact factor: 5.635

3.  Effects of intratracheally instilled laser printer-emitted engineered nanoparticles in a mouse model: A case study of toxicological implications from nanomaterials released during consumer use.

Authors:  Sandra V Pirela; Xiaoyan Lu; Isabelle Miousse; Jennifer D Sisler; Yong Qian; Nancy Guo; Igor Koturbash; Vincent Castranova; Treye Thomas; John Godleski; Philip Demokritou
Journal:  NanoImpact       Date:  2016-01-21

4.  A quantitative framework to group nanoscale and microscale particles by hazard potency to derive occupational exposure limits: Proof of concept evaluation.

Authors:  Nathan M Drew; Eileen D Kuempel; Ying Pei; Feng Yang
Journal:  Regul Toxicol Pharmacol       Date:  2017-08-05       Impact factor: 3.271

Review 5.  Characterizing risk assessments for the development of occupational exposure limits for engineered nanomaterials.

Authors:  P A Schulte; E D Kuempel; N M Drew
Journal:  Regul Toxicol Pharmacol       Date:  2018-03-21       Impact factor: 3.271

6.  Toxicity of lunar dust assessed in inhalation-exposed rats.

Authors:  Chiu-wing Lam; Robert R Scully; Ye Zhang; Roger A Renne; Robert L Hunter; Richard A McCluskey; Bean T Chen; Vincent Castranova; Kevin E Driscoll; Donald E Gardner; Roger O McClellan; Bonnie L Cooper; David S McKay; Linda Marshall; John T James
Journal:  Inhal Toxicol       Date:  2013-10       Impact factor: 2.724

7.  Pulmonary toxicity screening studies in male rats with TiO2 particulates substantially encapsulated with pyrogenically deposited, amorphous silica.

Authors:  D B Warheit; T R Webb; K L Reed
Journal:  Part Fibre Toxicol       Date:  2006-01-26       Impact factor: 9.400

8.  Translational toxicology in setting occupational exposure limits for dusts and hazard classification - a critical evaluation of a recent approach to translate dust overload findings from rats to humans.

Authors:  Peter Morfeld; Joachim Bruch; Len Levy; Yufanyi Ngiewih; Ishrat Chaudhuri; Henry J Muranko; Ross Myerson; Robert J McCunney
Journal:  Part Fibre Toxicol       Date:  2015-04-23       Impact factor: 9.400

9.  Equivalent titanium dioxide nanoparticle deposition by intratracheal instillation and whole body inhalation: the effect of dose rate on acute respiratory tract inflammation.

Authors:  Brittany L Baisch; Nancy M Corson; Pamela Wade-Mercer; Robert Gelein; Andrea J Kennell; Günter Oberdörster; Alison Elder
Journal:  Part Fibre Toxicol       Date:  2014-01-24       Impact factor: 9.400

10.  Irreversible pulmonary changes induced in rat lung by dust overload.

Authors:  B Bellmann; H Muhle; O Creutzenberg; R Mermelstein
Journal:  Environ Health Perspect       Date:  1992-07       Impact factor: 9.031

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.