Effect of passivation and surface modification on the dissolution behavior and nano-surface characteristics of Ti-6Al-4V in Hank/EDTA solution.

The aim of the present study was to investigate the effects of passivation treatment (34% nitric acid passivation, 400 ( composite function)C heated in air, and aged in 100 ( composite function)C de-ionized water) and surface modification (2 hr and 8 hr vacuum-brazed treatments) on the ion dissolution and nano-surface characteristics of Ti-6Al-4V exposed in Hank's solution with 8.0 mM ethylene diamine tetra-acetic acid (EDTA) at 37 ( composite function)C. The results indicated that the original nano-surface characteristics and microstructure would influence the ion dissolution but not change the capability of the Ca and P adsorption upon immersion. Of the three passivated treatments, 400 ( composite function)C thermal treatment for both 2 hr brazed Ti-6Al-4V (B2) and 8 hr brazed Ti-6Al-4V (B8) exhibits a substantial reduction in the constituent release compared to the acid passivated and water aged treatment, because the thicker thickness and rutile structure of surface oxide could provide the better dissolution resistance for 400 ( composite function)C-treated specimens. Moreover, the reduced Ti(2)Cu and increased alpha -titanium structure in B8 specimen could also improve ion dissolution resistance in comparison with B2 specimen. After soaking in Hank/EDTA solution, the adsorbed non-elemental Ca and P for all groups of specimens were observed by XPS analysis, and the AES depth-profile analysis indicate that the oxide films of all groups of specimens thicken with the longer immersion periods. The increasing oxide thickness may be the factor in the improved dissolution resistance at the longer immersion periods. The relation between lower dissolution rate and thicker oxide films were observed for all groups of specimens. The results suggest that the dissolution kinetics was governed by the metal ion transport through the oxide film in this study.