Michael D Kazel1, Jon K Sekiya, Jeffrey A Greene, Charles T Bruker. 1. Bone and Joint/Sports Medicine Institute, Department of Orthopaedic Surgery, Uniformed Services University of the Health Sciences, Naval Medical Center Portsmouth, Portsmouth, Virginia, USA.
Abstract
PURPOSE: The goal of our study was to determine whether a bone tamp could be used to correct a Hill-Sachs lesion by a unique technique that we developed termed "humeroplasty." TYPE OF STUDY: In vitro cadaveric study. METHODS: We created reproducible Hill-Sachs lesions in 14 cadaveric humerii, which we then reduced with a curved bone tamp using our proposed technique. Paired t tests, with the significance set at P < .05, were then used to compare the prereduction and postreduction depths, widths, lengths, and volumes of the lesions. RESULTS: The average prereduction defect measurements were 8.9 mm deep, 16.3 mm wide, 24.1 mm long, and 1,755 mm3 in volume. The average postreduction defect measurements were 1.6 mm deep, 6.2 mm wide, 10.4 mm long, and 50.3 mm3 in volume. A statistically significant improvement (P < .001) was seen in all parameters. CONCLUSIONS: Our technique was able to consistently and significantly restore all measured parameters of the Hill-Sachs lesions using a curved bone tamp. This reduction to a "small" defect may reduce the higher rate of recurrence normally found with the surgical treatment of shoulder instability when "large" Hill-Sachs lesions are present. CLINICAL RELEVANCE: Humeroplasty potentially might reduce the higher rate of recurrence observed when the surgical treatment of shoulder instability involves the presence of large Hill-Sachs lesions.
PURPOSE: The goal of our study was to determine whether a bone tamp could be used to correct a Hill-Sachs lesion by a unique technique that we developed termed "humeroplasty." TYPE OF STUDY: In vitro cadaveric study. METHODS: We created reproducible Hill-Sachs lesions in 14 cadaveric humerii, which we then reduced with a curved bone tamp using our proposed technique. Paired t tests, with the significance set at P < .05, were then used to compare the prereduction and postreduction depths, widths, lengths, and volumes of the lesions. RESULTS: The average prereduction defect measurements were 8.9 mm deep, 16.3 mm wide, 24.1 mm long, and 1,755 mm3 in volume. The average postreduction defect measurements were 1.6 mm deep, 6.2 mm wide, 10.4 mm long, and 50.3 mm3 in volume. A statistically significant improvement (P < .001) was seen in all parameters. CONCLUSIONS: Our technique was able to consistently and significantly restore all measured parameters of the Hill-Sachs lesions using a curved bone tamp. This reduction to a "small" defect may reduce the higher rate of recurrence normally found with the surgical treatment of shoulder instability when "large" Hill-Sachs lesions are present. CLINICAL RELEVANCE: Humeroplasty potentially might reduce the higher rate of recurrence observed when the surgical treatment of shoulder instability involves the presence of large Hill-Sachs lesions.
Authors: Alexandra L Brooks-Hill; Bruce B Forster; Case van Wyngaarden; Robert Hawkins; William D Regan Journal: Clin Orthop Relat Res Date: 2013-05-08 Impact factor: 4.176
Authors: Suraj Trivedi; Michael L Pomerantz; Daniel Gross; Petar Golijanan; Matthew T Provencher Journal: Clin Orthop Relat Res Date: 2014-08 Impact factor: 4.176
Authors: Gunther H Sandmann; Philipp Ahrens; Christoph Schaeffeler; Jan S Bauer; Chlodwig Kirchhoff; Frank Martetschläger; Dirk Müller; Sebastian Siebenlist; Peter Biberthaler; Ulrich Stöckle; Thomas Freude Journal: Int Orthop Date: 2012-08-24 Impact factor: 3.075