Three-dimensional vasculature of the bovine liver.

To clarify anatomical distribution of Fasciola infection, the vascular and ductal architectures of the liver were studied by means of corrosion cast technique using synthetic resin. The arteria hepatica propria (AP) passes as the arteria gastroduodenalis (AG); AP becomes the left trunk after the porta hepatis; AP passes on the right side of vena porta communis (VPC) and projects AG while curving in a U-shape below the portal vein. Hepatic veins located between the vena hepatica media (HM) and vena hepatica dextra (HD) varied widely among specimens and were irregular, including the vena hepatica dorso-lateralis sinistra (Hds), vena hepatica dorso-lateralis dextra (Hdd), vena hepatica lobi caudati (Hlc), venae hepaticae processus caudati (Hpc), venae hepaticae processus papillaris (Hpp), and the hepatic vein to the dorsal intermediate part, which directly or indirectly drained into the vena cava caudalis. The courses of the bovine hepatic veins were markedly diverse, and anastomoses between vena hepatica sinistra (HS) and Hds were observed in about a half of the livers. The portal vein entered the liver as VPC slightly above the centre of the right lobe on the visceral surface. The intermediate or transverse part [pars transversa trunci sinistri (PTS)] of truncus sinister (TS), which extends from the entry of the portal vein into the left lobe of the liver, was slightly arched downward [pars umbilicalis trunci sinistri (PUS)]. The portal vein further arched from the distal end of TS to the umbilical vein and ran towards the inter-lobar incision between the left lobe and quadrate lobe. Based on these branches, hepatic segments were determined as 13 or 14 areas. A total of 15 bile ducts were derived from various lobes. The hepatic duct was about 2.6-6 cm long from the confluence of the right and left hepatic ducts to the division of the cystic duct and the common hepatic duct.