Literature DB >> 1628609

Gain effects on performance using a head-controlled computer input device.

M L Lin1, R G Radwin, G C Vanderheiden.   

Abstract

The purpose of this study was to use a Fitts' task to (1) determine how control-display gain influences performance using a head-controlled computer input device; (2) compare relative sensitivity to gain and optimal gain between head control and hand/arm control; and (3) investigate control-display gain interactions with other task factors including target width, movement amplitude and direction. The task was a discrete target acquisition task using circular targets of 2.9 mm, 8.1 mm, and 23.5 mm, movement amplitudes of 24.3 mm and 61.7 mm, and eight radial directions including 0 degrees, 45 degrees, 90 degrees, 135 degrees, 180 degrees, 225 degrees, 270 degrees, and 315 degrees. Each device was operated at four gain levels. Ten subjects participated. The results indicated that gain had a significant effect on movement time for both types of pointing devices and exhibited local minimums. Discrete target acquisition at all gains was aptly described using Fitts' Law for both input devices. The mouse gain resulting in minimum movement time and RMS cursor deviation was between 1.0 and 2.0. The minimum movement time and RMS cursor deviation for the head-controlled pointer occurred at a gain between 0.3 and 0.6. Average movement time at the optimal head-controlled pointer gain had a slope of 169 ms/bit and was more than 76% greater than at the optimal mouse gain with a slope of 135 ms/bit. In addition, average RMS displacement was more than 27% greater for the head-controlled pointer at its optimal gain setting than for the mouse. Gain had the greatest effect for small target widths and long movement amplitudes using the head-controlled pointer. Average movement time increased 37% when increasing the head-controlled pointer gain from 0.6 to 1.2 for the small target width, but only increased 0.3% when increasing gain for the large target width. Average movement time also increased 12% when decreasing the head-controlled pointer gain from 0.3 to 0.15 for the long movement amplitude, but decreased 0.3% when decreasing gain for the short movement amplitude.

Entities:  

Mesh:

Year:  1992        PMID: 1628609     DOI: 10.1080/00140139208967804

Source DB:  PubMed          Journal:  Ergonomics        ISSN: 0014-0139            Impact factor:   2.778


  4 in total

1.  Visual layout modulates Fitts's law: the importance of first and last positions.

Authors:  Jay Pratt; Jos J Adam; Martin H Fischer
Journal:  Psychon Bull Rev       Date:  2007-04

2.  Influence of the mechanical properties of a manipulandum on human operator dynamics. II. Viscosity.

Authors:  L A Jones; I W Hunter
Journal:  Biol Cybern       Date:  1993       Impact factor: 2.086

3.  Signal-independent noise in intracortical brain-computer interfaces causes movement time properties inconsistent with Fitts' law.

Authors:  Francis R Willett; Brian A Murphy; William D Memberg; Christine H Blabe; Chethan Pandarinath; Benjamin L Walter; Jennifer A Sweet; Jonathan P Miller; Jaimie M Henderson; Krishna V Shenoy; Leigh R Hochberg; Robert F Kirsch; A Bolu Ajiboye
Journal:  J Neural Eng       Date:  2017-02-08       Impact factor: 5.379

4.  Development and evaluation of a head-controlled human-computer interface with mouse-like functions for physically disabled users.

Authors:  César Augusto Martins Pereira; Raul Bolliger Neto; Ana Carolina Reynaldo; Maria Cândida de Miranda Luzo; Reginaldo Perilo Oliveira
Journal:  Clinics (Sao Paulo)       Date:  2009       Impact factor: 2.365

  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.