Oxygen plasma-treatment effects on Si transfer.

Oxygen plasma-treatment is commonly used to increase the hydrophilicity of poly(dimethylsiloxane) (PDMS) stamps used for microcontact printing (muCP) aqueous-based inks. Review of the literature reveals that a wide range of plasma parameters are currently employed to modify stamp surfaces. However, little is known about the effect of these parameters (e.g., power, chamber pressure, duration) on the undesirable transfer of low-molecular-weight silicon-containing fragments from the stamps that commonly occurs during muCP. To study the effect of oxygen plasma-treatment on Si transfer, unpatterned PDMS stamps were treated with oxygen plasma under various conditions and used to stamp deionized water on plasma-activated poly(methyl methacrylate) (PMMA) substrates. Once stamped, the PMMA substrates were analyzed with X-ray photoelectron spectroscopy (XPS) to quantify and characterize silicon present on the substrate surface. In addition, used PDMS stamps were analyzed with scanning electron microscopy (SEM) to observe topographical changes that occur during oxygen plasma-treatment. XPS results show that all plasma treatments studied significantly reduced the amount of Si transfer from the treated stamps during muCP as compared to untreated PDMS stamps and that the source of transfer is residual PDMS fragments not removed by oxygen plasma. SEM results show that, although the treated stamps undergo a variety of topographical changes, no correlation exists between stamp topography and extent of Si transfer from the stamps.