Literature DB >> 15945022

The high-mass component (>m/z 10 000) of coal tar pitch by matrix-assisted laser desorption/ionisation mass spectrometry and size-exclusion chromatography.

Marcos Millan1, Trevor J Morgan, Mahtab Behrouzi, Fatma Karaca, Carolina Galmes, Alan A Herod, Rafael Kandiyoti.   

Abstract

The size-exclusion chromatography (SEC) of acetone-soluble, pyridine-soluble and pyridine-insoluble fractions of a coal tar pitch indicates a bimodal distribution in each fraction. The proportion of high-mass material excluded from the SEC column porosity increases with solvent polarity. The polymer calibration of SEC shows the mass range of the small molecules to be from approximately 100 u to approximately 6000 u, with the mass range of the large excluded molecules above 200 000 u and up to several million u. In contrast, matrix-assisted laser desorption/ionisation mass spectrometry (MALDI-MS) shows a similar low-mass range of ion abundances (< m/z 6000), but with a smaller range of high-mass ion abundances, from approximately m/z 10 000 to 100 000. The large molecules may have three-dimensional structures to allow molecules of relatively low mass to behave as if they are of large size in SEC. Laser desorption mass spectrometry of the acetone- and pyridine-soluble fractions produced molecular ions of polycyclic aromatics that can be related to the known compositions from gas chromatography (GC) mass spectrometry. The experimental conditions used to generate the bimodal distribution by MALDI-MS involve reducing the ion signal intensities to avoid overload of the detector and enable detection of the high-mass ions, by reducing the high-mass detector voltage (i.e. sensitivity) and increasing the laser power. Copyright (c) 2005 John Wiley & Sons, Ltd.

Entities:  

Year:  2005        PMID: 15945022     DOI: 10.1002/rcm.1997

Source DB:  PubMed          Journal:  Rapid Commun Mass Spectrom        ISSN: 0951-4198            Impact factor:   2.419


  1 in total

1.  Preparation of organic light-emitting diode using coal tar pitch, a low-cost material, for printable devices.

Authors:  Miki Yamaoka; Shun-Suke Asami; Nayuta Funaki; Sho Kimura; Liao Yingjie; Takeshi Fukuda; Makoto Yamashita
Journal:  PLoS One       Date:  2013-05-07       Impact factor: 3.240

  1 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.