Literature DB >> 15924346

A numerical evaluation of SAR distribution and temperature changes around a metallic plate in the head of a RF exposed worker.

Robert L McIntosh1, Vitas Anderson, Raymond J McKenzie.   

Abstract

The 1998 International Commission for Non-Ionising Radiation (ICNIRP) Guidelines for human exposure to radiofrequency (RF) fields contain a recommendation to assess the potential impact of metallic implants in workers exposed up to the allowable occupational field limits. This study provides an example of how numerical electromagnetic (EM) and thermal modelling can be used to determine whether scattered RF fields around metallic implants in workers exposed to allowable occupational ambient field limits will comply with the recommendations of relevant standards and guidelines. A case study is performed for plane wave exposures of a 50 mm diameter titanium cranioplasty plate, implanted around 5-6 mm under the surface of the forehead. The level of exposures was set to the ambient power flux density limits for occupational exposures specified in the 1998 ICNIRP guidelines and the current 1999 IEEE C95.1 standard over the frequency range 100-3000 MHz. Two distinct peak responses were observed. There was a resonant response for the whole implant at 200-300 MHz where the maximum dimension of the implant is around a third of the wavelength of the RF exposure. This, however, resulted in relatively low peak specific energy absorption rate (SAR) levels around the implant at the exposure limits. Between 2100-2800 MHz, a second SAR concentrating mechanism of constructive interference of the wave reflected back and forth between the air-scalp interface and the scalp-plate interface resulted in higher peak SARs that were within the allowable limits for the ICNIRP exposures, but not for the IEEE C95.1 exposures. Moreover, the IEEE peak SAR limits were also exceeded, to a lesser degree, even when the implant was not present. However, thermal modelling indicated that the peak SAR concentrations around the implant did not result in any peak temperature rise above 1 degrees C for occupational exposures recommended in the ICNIRP guidelines, and hence would not pose any significant health risk. Copyright 2005 Wiley-Liss, Inc.

Entities:  

Mesh:

Year:  2005        PMID: 15924346     DOI: 10.1002/bem.20112

Source DB:  PubMed          Journal:  Bioelectromagnetics        ISSN: 0197-8462            Impact factor:   2.010


  7 in total

1.  Heat transfer analysis in an uncoiled model of the cochlea during magnetic cochlear implant surgery.

Authors:  Fateme Esmailie; Mathieu Francoeur; Tim Ameel
Journal:  Int J Heat Mass Transf       Date:  2020-04-16       Impact factor: 5.584

2.  Experimental Validation of a Three-Dimensional Heat Transfer Model Within the Scala Tympani With Application to Magnetic Cochlear Implant Surgery.

Authors:  Fateme Esmailie; Mathieu Francoeur; Tim Ameel
Journal:  IEEE Trans Biomed Eng       Date:  2021-08-23       Impact factor: 4.756

3.  Enhancement of Apoptosis by Titanium Alloy Internal Fixations during Microwave Treatments for Fractures: An Animal Study.

Authors:  Gang Wang; Yiming Xu; Lina Zhang; Dongmei Ye; Xianxuan Feng; Tengfei Fu; Yuehong Bai
Journal:  PLoS One       Date:  2015-07-01       Impact factor: 3.240

4.  Comparative study of the proliferative ability of skeletal muscle satellite cells under microwave irradiation in fractures with titanium alloy internal fixation in rabbits.

Authors:  Yuzhen Zou; Gang Wang; Yiming Xu; Yuehong Bai
Journal:  Exp Ther Med       Date:  2018-10-01       Impact factor: 2.447

5.  Effects of low-dose microwave on healing of fractures with titanium alloy internal fixation: an experimental study in a rabbit model.

Authors:  Dongmei Ye; Yiming Xu; Han Zhang; Tengfei Fu; Lan Jiang; Yuehong Bai
Journal:  PLoS One       Date:  2013-09-26       Impact factor: 3.240

6.  Low dose of continuous-wave microwave irradiation did not cause temperature increase in muscles tissue adjacent to titanium alloy implants--an animal study.

Authors:  Dongmei Ye; Yiming Xu; Tengfei Fu; Han Zhang; Xianxuan Feng; Gang Wang; Lan Jiang; Yuehong Bai
Journal:  BMC Musculoskelet Disord       Date:  2013-12-23       Impact factor: 2.362

7.  Modelling and Evaluating Electromagnetic Field Exposure in the Multiple-Source Scenario of Using IoT HF RFID Readers.

Authors:  Patryk Zradziński
Journal:  Int J Environ Res Public Health       Date:  2022-03-10       Impact factor: 3.390

  7 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.