Low-fat mozzarella as influenced by microbial exopolysaccharides, preacidification, and whey protein concentrate.

Low-fat Mozzarella cheeses containing 6% fat were made by preacidification of milk, preacidification combined with exopolysaccharide- (EPS-) producing starter, used independently or as a coculture with non-EPS starter, and preacidification combined with whey protein concentrate (WPC) and EPS. The impact of these treatments on moisture retention, changes in texture profile analysis, cheese melt, stretch, and on pizza bake performance were investigated over 45 d of storage at 4 degrees C. Preacidified cheeses without EPS (control) had the lowest moisture content (53.75%). These cheeses were hardest and exhibited greatest springiness and chewiness. The meltability and stretchability of these cheeses increased most during the first 28 d of storage. The moisture content in cheeses increased to 55.08, 54.79, and 55.82% with EPS starter (containing 41.18 mg/g of EPS), coculturing (containing 28.61 mg/g of EPS), and WPC (containing 44.23 mg/g of EPS), respectively. Exopolysaccharide reduced hardness, springiness, and chewiness of low-fat cheeses made with preacidified milk in general and such cheeses exhibited an increase in cohesiveness and meltability. Although stretch distance was similar in all cheeses, those containing EPS were softer than the control. Cocultured cheeses exhibited the greatest meltability. Cheeses containing WPC were softest in general; however, hardness remained unchanged over 45 d. Cheeses made with WPC had the least increase in meltability over time. Incorporation of WPC did not reduce surface scorching or increase shred fusion of cheese shreds during pizza baking; however, there was an improvement in these properties between d 7 and 45. Coating of the cheese shreds with oil was necessary for adequate browning, melt, and flow characteristics in all cheese types.