OBJECTIVE: This study evaluated the incidence and persistence of adhesions following intraperitoneal onlay mesh fixation with tissue soldering in an experimental model. METHODS: Anesthetized New Zealand white rabbits (n = 21), weighing 2.8-3.2 kg, underwent laparotomy. Controls (group 1 [n = 3]) had 2 x 2 cm Mersilene (Ethicon, Somerville, New Jersey) polyester mesh segments fixed to the peritoneum with staples (USSC, Norwalk, Connecticut). Group 2 (n = 7) rabbits had Mersilene mesh affixed by melting 55% collagen solder using a prototype laser (1.43 micro, 2.5 W CW, 4 mm spot size, 60 degrees C set temperature) over mesh. Group 3 (n = 6) rabbits had Vicryl (Ethicon, Somerville, New Jersey) polyglactin mesh embedded in 60% collagen solder placed onto the peritoneum and fixed with identical laser parameters as group 2. Group 4 (n = 5) rabbits had 55% collagen solder placed and Mersilene pressed into it after melting. Four segments were placed in each experimental animal. Animals were euthanized at 2, 4, or 6 weeks. Adhesions were graded (0 = none; I = filmy adhesions; II = omental; III = bowel adhesions gently lysed; IV = dense adhesions requiring sharp dissection). RESULTS: Grade III adhesions were observed in both control and group 4 animals at 2 weeks, persisting in group 4 animals at 6 weeks, but having lysed in controls at 6 weeks. No adhesions were present in group 3 specimens at any interval. Grade I adhesions were present in group 2 at 2 weeks at exposed mesh areas, and declined in frequency at 6 weeks. Evidence of reabsorption of the polyglactin mesh-solder composite was apparent in the group 3 specimens at 4 weeks, and complete resorption had occurred by 6 weeks postoperatively. DISCUSSION: Laser-assisted solder fixation caused minimal adhesion formation when mesh was covered by solder. Adhesions were observed if Mersilene mesh material was exposed to the abdominal contents. Vicryl mesh-solder composites reabsorbed without inflammation, scarring, or adhesions at the sites of mesh fixation. CONCLUSION: Further development of this technology is warranted.
OBJECTIVE: This study evaluated the incidence and persistence of adhesions following intraperitoneal onlay mesh fixation with tissue soldering in an experimental model. METHODS: Anesthetized New Zealand white rabbits (n = 21), weighing 2.8-3.2 kg, underwent laparotomy. Controls (group 1 [n = 3]) had 2 x 2 cm Mersilene (Ethicon, Somerville, New Jersey) polyester mesh segments fixed to the peritoneum with staples (USSC, Norwalk, Connecticut). Group 2 (n = 7) rabbits had Mersilene mesh affixed by melting 55% collagen solder using a prototype laser (1.43 micro, 2.5 W CW, 4 mm spot size, 60 degrees C set temperature) over mesh. Group 3 (n = 6) rabbits had Vicryl (Ethicon, Somerville, New Jersey) polyglactin mesh embedded in 60% collagen solder placed onto the peritoneum and fixed with identical laser parameters as group 2. Group 4 (n = 5) rabbits had 55% collagen solder placed and Mersilene pressed into it after melting. Four segments were placed in each experimental animal. Animals were euthanized at 2, 4, or 6 weeks. Adhesions were graded (0 = none; I = filmy adhesions; II = omental; III = bowel adhesions gently lysed; IV = dense adhesions requiring sharp dissection). RESULTS: Grade III adhesions were observed in both control and group 4 animals at 2 weeks, persisting in group 4 animals at 6 weeks, but having lysed in controls at 6 weeks. No adhesions were present in group 3 specimens at any interval. Grade I adhesions were present in group 2 at 2 weeks at exposed mesh areas, and declined in frequency at 6 weeks. Evidence of reabsorption of the polyglactin mesh-solder composite was apparent in the group 3 specimens at 4 weeks, and complete resorption had occurred by 6 weeks postoperatively. DISCUSSION: Laser-assisted solder fixation caused minimal adhesion formation when mesh was covered by solder. Adhesions were observed if Mersilene mesh material was exposed to the abdominal contents. Vicryl mesh-solder composites reabsorbed without inflammation, scarring, or adhesions at the sites of mesh fixation. CONCLUSION: Further development of this technology is warranted.
Authors: Raymond J Lanzafame; Istvan Stadler; Ryan Cunningham; Aaron Muhlbauer; Jacob Griggs; Robert Soltz; Barbara A Soltz Journal: Photomed Laser Surg Date: 2013-10-19 Impact factor: 2.796