The development of a quantitative flexibility test for body armour and comparison with wearer trials.

In this paper a mechanical flexibility test is developed which can be used to assess multi layer body armour systems. This is compared with a subjective manual test, and then with the results of wearer trials conducted using the recently approved ISO body armour standard ISO 14876-1 (2002). A series of trials was conducted on six different ballistic and/or stab resistant body armour types with a variety of protection levels and constructions. These were tested using the mechanical test system in which the armour was forced through a 200 mm hole by a 100 mm hemispherical plunger. The results of this test were then compared to a second set of trials in which flexibility of the same armour was assessed by manual handling and flexing of the armour. Finally an ergonomic wearer trial was conducted with four armours according to ISO 14876-1 (2002) each armour being assessed by four volunteers and the results compared to flexibility data collected in the first two trials. It was shown that the mechanical flexibility test produced results which were in good agreement with a purely subjective flexibility assessment. These results in turn showed reasonable but not exact correlation with the wearer trials. The ISO wearer trials addressed other factors such as overall comfort and fit of the systems and so the results were not purely a function of flexibility.