Literature DB >> 15826022

Investigation of the potential utility of single-bounce attenuated total reflectance Fourier transform infrared spectroscopy in the analysis of distilled liquors and wines.

Robert A Cocciardi1, Ashraf A Ismail, Jacqueline Sedman.   

Abstract

A new Fourier transform infrared (FTIR) spectroscopic method based on single-bounce attenuated total reflectance (SB-ATR) spectroscopy was developed for the analysis of distilled liquors and wines. For distilled liquors, a partial least-squares (PLS) calibration was developed for alcohol determination based on the SB-ATR/FTIR spectra of mixtures of ethanol and distilled water. An independent set of 12 different distilled liquor samples was predicted from the PLS calibration, and a standard deviation of the differences for accuracy (SDD(a)) between actual and predicted values of 0.142% (v/v) was obtained. The potential utility of SB-ATR/FTIR spectroscopy for the analysis of wines was initially evaluated based on a comparison with Fourier transform near-infrared (FT-NIR) spectroscopy and FTIR spectroscopy using a flow-through transmission cell. PLS calibrations for alcohol, total reducing sugars, total acidity and pH were developed using pre-analyzed wine samples (n = 28), and for SB-ATR/FTIR spectroscopy, the SDD(a) for the leave-one-out cross-validation statistics were of the order of 0.100% (v/v), 0.707 g L(-1), 0.189 g L(-1) (H2SO4), and 0.230, respectively. Overall, the SB-ATR/FTIR results were better than those obtained using FT-NIR spectroscopy and comparable to those obtained with transmission FTIR spectroscopy. A PLS calibration based on preanalyzed wine samples (n = 72) for the prediction of 11 different components and parameters in wines by SB-ATR/FTIR spectroscopy was subsequently developed and validated using an independent sample set (n = 77). Good coefficients of correlation between the reference and predicted values for the validation set were obtained for most of the components and parameters except citric acid, volatile acids, and total SO2. The results of this study demonstrate the suitability of SB-ATR/FTIR spectroscopy for the routine analysis of distilled liquors and wines.

Entities:  

Mesh:

Year:  2005        PMID: 15826022     DOI: 10.1021/jf048663d

Source DB:  PubMed          Journal:  J Agric Food Chem        ISSN: 0021-8561            Impact factor:   5.279


  3 in total

1.  Rapid and mobile determination of alcoholic strength in wine, beer and spirits using a flow-through infrared sensor.

Authors:  Dirk W Lachenmeier; Rolf Godelmann; Markus Steiner; Bob Ansay; Jürgen Weigel; Gunther Krieg
Journal:  Chem Cent J       Date:  2010-03-23       Impact factor: 4.215

2.  Non-destructive determination of ethanol levels in fermented alcoholic beverages using Fourier transform mid-infrared spectroscopy.

Authors:  Ayalew Debebe; Mesfin Redi-Abshiro; Bhagwan Singh Chandravanshi
Journal:  Chem Cent J       Date:  2017-03-24       Impact factor: 4.215

3.  Geographical origin traceability of Cabernet Sauvignon wines based on Infrared fingerprint technology combined with chemometrics.

Authors:  Xiao-Zhen Hu; Si-Qi Liu; Xiao-Hong Li; Chuan-Xian Wang; Xin-Lu Ni; Xia Liu; Yang Wang; Yuan Liu; Chang-Hua Xu
Journal:  Sci Rep       Date:  2019-06-04       Impact factor: 4.379

  3 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.