Root surface temperature rises in vitro during root canal obturation using hybrid and microseal techniques.

The aim of this in vitro study was to measure the temperature rise on the outer surface of roots during filling with hybrid technique and Microseal. Twenty extracted human maxillary and mandibular premolars with a single canal were randomly divided into two groups of 10 teeth each. In the first group, the teeth were filled with hybrid technique (thermomechanical compaction with Engine Plugger used following lateral condensation of the apical part of the canal), the second group was filled using Microseal. After root canal obturation the filling material was removed and the obturation procedure was repeated. A total of 20 obturations in each group were performed. Temperature changes were measured using a thermal imaging camera. The temperature of certain regions of the mesial surface was analyzed and the highest temperature values were recorded. Statistical analysis was performed using the Mann-Whitney U test. The mean increase of temperature during the hybrid technique with Engine Plugger was 23.8 degrees C, while during Microseal it was significantly lower (p = 0.000001) at 5.5 degrees C. The temperature rise generated by Microseal was below the critical level and should not damage supporting structures, however, the hybrid technique generated a relatively high temperature rise that may cause periodontal tissue damage.