Compression of controlled-release pellets produced by a hot-melt extrusion and spheronization process.

The purpose of this study was to investigate the physicomechanical and dissolution properties of tablets containing controlled-release pellets prepared by a hot-melt extrusion and spheronization process. A powder blend of anhydrous theophylline, Eudragit Preparation 4135 F, and functional excipients was melt-extruded, pelletized, and then spheronized. The pellets were compressed into tablets using forces of 5, 10, 15, and 20 kN. Tablet diluents included microcrystalline cellulose, a mixture of spray-dried lactose and microcrystalline cellulose, modified food starch, and soy polysaccharides. The effective porosity of the compressed pellets was measured using mercury porosimetry and helium pycnometry, while the surface area was determined using Brunauer, Emmett, and Teller (BET) analysis. The disintegration time, hardness, and friability of compacts were determined. Drug release studies were performed according to USP 27 Apparatus 3 guidelines in 250 mL of medium (pH 1.0, 3.0, 5.0, 6.8, and 7.4) 37 degrees C and 20 dpm. Samples were analyzed by high pressure-liquid chromatography (HPLC). Effective porosity and surface area determinations of the melt-extruded pellets were not influenced by compression. The percent of theophylline released from rapidly disintegrating tablets was not affected by compression force or excipient selection, but tablets with prolonged disintegration times exhibited delayed drug release in acidic media. However, dissolution profiles of uncompressed pellets and all compacts were identical after transition from 0.1 N HCl to media increasing in pH from 3.0 to 7.4. Furthermore, pellet to filler excipient ratio and filler excipient selection did not influence the rate of drug release from compacts.