OBJECTIVE: To compare the biomechanical properties of pantarsal arthrodesis achieved with a dorsal bone plate-alone (BPA) or pin-plate combination (PPC). SAMPLE POPULATION: 8 pairs of cadaver canine tarsi. PROCEDURE: Within a pair, 1 tarsus was arthrodesed by use of a 13-hole 3.5-mm broad dynamic compression bone plate applied to the dorsal aspect of the tarsus; the paired tarsus received an identical plate similarly applied, with the addition of an intramedullary pin filling approximately 40% of the tibial medullary canal, spanning the tibiotarsal joint. Plates were instrumented with strain gauges proximal and distal to the solid portion of the plate. Specimens were mounted on a servo-hydraulic testing machine and loaded at 20%, 40%, and 80% of body weight for 10 cycles at 1 Hz. Construct compliance, angular deformation, and plate strain were determined during the 10th cycle. RESULTS: PPC specimens were less compliant than BPA specimens at all loads and had significantly less angular deformation than BPA specimens at loads of 40% and 80% of body weight. Tibiotarsal gauge microstrain was significantly less in PPC specimens, compared with BPA specimens, regardless of loads. Maximal strains were 33.5% to 40.5% less in PPC than BPA specimens. CONCLUSIONS AND CLINICAL RELEVANCE: For pantarsal arthrodesis in dogs, our results indicate that the PPC construct is biomechanically superior to the BPA construct. By improving construct stability, addition of an intramedullary pin to the traditional BPA technique may lessen implant-related complications and improve plate fatigue life. A subsequent decrease in postoperative morbidity may occur with little addition of time or complexity to the surgical procedure.
OBJECTIVE: To compare the biomechanical properties of pantarsal arthrodesis achieved with a dorsal bone plate-alone (BPA) or pin-plate combination (PPC). SAMPLE POPULATION: 8 pairs of cadaver canine tarsi. PROCEDURE: Within a pair, 1 tarsus was arthrodesed by use of a 13-hole 3.5-mm broad dynamic compression bone plate applied to the dorsal aspect of the tarsus; the paired tarsus received an identical plate similarly applied, with the addition of an intramedullary pin filling approximately 40% of the tibial medullary canal, spanning the tibiotarsal joint. Plates were instrumented with strain gauges proximal and distal to the solid portion of the plate. Specimens were mounted on a servo-hydraulic testing machine and loaded at 20%, 40%, and 80% of body weight for 10 cycles at 1 Hz. Construct compliance, angular deformation, and plate strain were determined during the 10th cycle. RESULTS: PPC specimens were less compliant than BPA specimens at all loads and had significantly less angular deformation than BPA specimens at loads of 40% and 80% of body weight. Tibiotarsal gauge microstrain was significantly less in PPC specimens, compared with BPA specimens, regardless of loads. Maximal strains were 33.5% to 40.5% less in PPC than BPA specimens. CONCLUSIONS AND CLINICAL RELEVANCE: For pantarsal arthrodesis in dogs, our results indicate that the PPC construct is biomechanically superior to the BPA construct. By improving construct stability, addition of an intramedullary pin to the traditional BPA technique may lessen implant-related complications and improve plate fatigue life. A subsequent decrease in postoperative morbidity may occur with little addition of time or complexity to the surgical procedure.