Adsorption of organic matter at mineral/water interfaces: 3. Implications of surface dissolution for adsorption of oxalate.

The adsorption of oxalate on a model aluminum oxide, corundum (alpha-Al2O3), has been examined over a broad range of oxalate concentrations (0.125-25.0 mM) and pH conditions (2-10). In situ attenuated total reflectance Fourier transform infrared (ATR-FTIR) measurements indicate that at low to intermediate concentrations ([oxalate] < or = 2.50 mM), oxalate adsorbs to corundum predominantly as a bidentate, mononuclear, inner-sphere complex involving both carboxyl groups. Significant contributions from outer-spherically bound oxalate and aqueous Ox(2-) are additionally observed at higher oxalate concentrations. Consistent with the ATR-FTIR findings, macroscopic adsorption data measured for oxalate concentrations of 0.125-2.50 mM can be generally well modeled with a single bidentate, inner-sphere oxalate complex using the charge distribution multisite complexation (CD-MUSIC) model. However, at intermediate oxalate concentrations (0.50 and 1.25 mM) and pH <5, the extent of oxalate adsorption measured experimentally is found to fall significantly below that predicted by CD-MUSIC simulations. The latter finding is interpreted in terms of competition for oxalate from dissolved Al(III), the formation of which is promoted by the dissolution-enhancing properties of the adsorbed oxalate anion. In accordance with this expectation, increasing concentrations of dissolved Al(III) in solution are found to significantly decrease the extent of oxalate adsorption on corundum under acidic pH conditions, presumably through promoting the formation of Al(III)-oxalate complexes with reduced affinities for the corundum surface compared with the uncomplexed oxalate anion.