Characterization of perivascular poly(lactic-co-glycolic acid) films containing paclitaxel.

The objectives of this study were to investigate the use of poly(lactic-co-glycolic acid) (PLGA) for the formulation of paclitaxel loaded films and to characterize these films for potential application as perivascular "wraps" to prevent restenosis. Films were manufactured from PLGA blended with either methoxypolyethylene glycol (MePEG) or a diblock copolymer composed of poly(D,L-lactic acid)-block-methoxypolyethylene glycol, PDLLA-MePEG (diblock) by solvent evaporation on teflon discs. Elasticity was determined by gravimetric stress/strain analysis. Thermal analysis was determined using differential scanning calorimetry (DSC). Changes in film composition and degradation in aqueous media were determined using gel permeation chromatography (GPC). Paclitaxel release from films was measured by incubation of the films in phosphate buffered saline (PBS) with drug analysis by HPLC methods. The addition of MePEG or diblock to PLGA caused a concentration dependent increase in the elasticity of films, due to plasticizing effects. DSC analysis showed that MePEG and diblock caused a concentration dependent decrease in the glass transition temperature (Tg) of PLGA indicating miscibility of the polymers. When placed in aqueous media, more than 75% of MePEG dissolved out of the PLGA films within 2 days, whereas diblock partitioned slowly and in a controlled manner out of the films. Paclitaxel release from PLGA/MePEG films was very slow with less than 5% of the encapsulated drug being released over 2 weeks. The addition of 30% diblock to paclitaxel loaded PLGA films caused a substantial increase (five- to eight-fold) in the release rate of paclitaxel. PLGA films containing 30% diblock and either 1% or 5% paclitaxel were partially or completely degraded following perivascular implantation in rats.