Evaluation of common organic solvents for gas chromatographic analysis and stability of multiclass pesticide residues.

In this study, we evaluated the suitability of six common organic solvents for gas chromatographic (GC) analysis of pesticides. Three of these, acetone, acetonitrile (MeCN) and ethyl acetate (EtAc), represent extraction solvents commonly used in multiresidue methods for determination of pesticides in produce. The other three, isooctane, hexane and toluene, often serve as exchange solvents before a GC analysis. An ideal solvent for GC analysis of multiclass pesticide residues should be compatible with: the analytes, sample preparation, and GC analysis. This study addresses each aspect with emphasis placed on stability of selected pesticides in the given solvents. In this respect, the exchange solvents proved to be superior to the more polar extraction solvents. Degradation of N-trihalomethylthio fungicides (e.g., captan, folpet, dichlofluanid) in MeCN was observed only in certain lots of the tested MeCN, but even if it occurred, the stability of these analytes as well as that of dicofol and chlorothalonil was dramatically improved by the addition of 0.1% (v/v) acetic acid. Dicofol and chlorothalonil were also unstable in acetone, and pesticides with a thioether group (e.g., fenthion, disulfoton) degraded in the tested EtAc. Formation of isomers of certain pyrethroids (deltamethrin, lambda-cyhalothrin) was recorded in the chromatograms from MeCN and acetone solutions, but this effect more likely occurred during the GC injection than in solution. For several reasons, MeCN was found to be the most suitable solvent for extraction of a wide polarity range of pesticide residues from produce. After acidification, the stability of problematic pesticides in MeCN is acceptable, and MeCN can also serve as a medium for GC injection; therefore solvent exchange is generally not required before GC analysis. If sensitivity is an issue in splitless injection, then toluene was demonstrated to be the best exchange solvent due to its miscibility with MeCN and stronger responses of relatively more polar pesticides (e.g., acephate, methamidophos) as compared to hexane and isooctane.