In vitro laser ablation of laboratory developed biofilms using an Nd:YAG laser of 532 nm wavelength.

We studied the laser ablation of laboratory-developed biofilm on titanium and glass surfaces. Specifically, Pseudoalteromonas carrageenovora, a marine biofilm forming bacterium was used to generate laboratory biofilm. Two fluences, 0.05 and 0.1 J/cm(2) and three durations of irradiation, 30 s, 5 min, and 10 min were tested using an Nd;YAG laser of 532 nm wavelength (in the green light area). Nonirradiated coupons with biofilm served as control. The biofilm removal efficiency increased with the increase in laser fluence and duration of irradiation. The maximum biofilm area cover on control coupons of glass and titanium was 62.5 and 76.0%, respectively. Upon irradiation with fluence 0.1 J/cm(2) for the very short duration of 30 s, this reduced to 5.6 and 12.4% and at 10 min to 2.17 and 0.7% on glass and titanium coupons, respectively, while the controls did not show any reductions (62.5 and 76.0% respectively, for glass and titanium coupons). The biofilm TRC (Total Resuscitated Cells) reduction during this period was even more prominent than the area cover, indicating that the remaining biofilm portions on coupons after irradiation were largely composed of dead bacterial cells. The TRC in the irradiation chamber medium for short durations of irradiation showed a significant increase, indicating that the laser irradiation removed live bacteria from the biofilm. The re-growth of the resuscitated cells showed they could grow like the control cells but with a significant lag. The laser's efficiency in the removal of biofilm was better seen on titanium coupons than on glass. Our results showed that a low-power pulsed laser irradiation could be used to remove biofilm formed on hard surfaces. Copyright 2004 Wiley Periodicals, Inc.