Quantitation of transverse maxillary dimensions using computed tomography: a methodological and reproducibility study.

The present investigation was a methodological study of a new method of quantification of a series of factors in the transverse dimension of the maxilla including the nose, maxillary bones and dental arches, based on computer tomographic (CT) scanning. The aim was to investigate a series of parameters thought to be relevant in the differential diagnosis of discrepancies in the morphology of this area and probably affected by orthodontic appliances. Based on a standardized CT scanning registration of 10 subjects, a series of points on the scans were identified and then measured in a special cephalometric computer system (linear and angular values). The quantitation was repeated by each observer and inter- and intra-observer differences were calculated. The results demonstrated that virtually all the parameters showed a high degree of reproducibility at both levels and confirmed the statistical suitability of the method described. The method will be used in a series of ongoing studies regarding the morphology and treatment of discrepancies of the midface and therefore supplement the relatively sparse information based on quantitative reports concerning this important anatomical area.