Mapping quantitative trait loci in F2 incorporating phenotypes of F3 progeny.

In plants and laboratory animals, QTL mapping is commonly performed using F(2) or BC individuals derived from the cross of two inbred lines. Typical QTL mapping statistics assume that each F(2) individual is genotyped for the markers and phenotyped for the trait. For plant traits with low heritability, it has been suggested to use the average phenotypic values of F(3) progeny derived from selfing F(2) plants in place of the F(2) phenotype itself. All F(3) progeny derived from the same F(2) plant belong to the same F(2:3) family, denoted by F(2:3). If the size of each F(2:3) family (the number of F(3) progeny) is sufficiently large, the average value of the family will represent the genotypic value of the F(2) plant, and thus the power of QTL mapping may be significantly increased. The strategy of using F(2) marker genotypes and F(3) average phenotypes for QTL mapping in plants is quite similar to the daughter design of QTL mapping in dairy cattle. We study the fundamental principle of the plant version of the daughter design and develop a new statistical method to map QTL under this F(2:3) strategy. We also propose to combine both the F(2) phenotypes and the F(2:3) average phenotypes to further increase the power of QTL mapping. The statistical method developed in this study differs from published ones in that the new method fully takes advantage of the mixture distribution for F(2:3) families of heterozygous F(2) plants. Incorporation of this new information has significantly increased the statistical power of QTL detection relative to the classical F(2) design, even if only a single F(3) progeny is collected from each F(2:3) family. The mixture model is developed on the basis of a single-QTL model and implemented via the EM algorithm. Substantial computer simulation was conducted to demonstrate the improved efficiency of the mixture model. Extension of the mixture model to multiple QTL analysis is developed using a Bayesian approach. The computer program performing the Bayesian analysis of the simulated data is available to users for real data analysis.