Literature DB >> 14762916

Physical stability of salmon calcitonin spray-dried powders for inhalation.

Hak-Kim Chan1, Andrew R Clark, Jane C Feeley, Mei-Chang Kuo, S Russ Lehrman, Katherine Pikal-Cleland, Danforth P Miller, Reinhard Vehring, David Lechuga-Ballesteros.   

Abstract

The effects of excipient crystallinity and water content on the physical stability of salmon calcitonin (sCT) in a spray-dried powder for inhalation have been investigated. sCT was dissolved in water with and without mannitol and then spray dried using a Büchi 190 spray dryer. The spray dried powders were stored for 5 days at 0, 29, 51, 58, 69, and 84% relative humidity at ambient temperature. The crystalline content, water content, secondary structure, and aggregation rates were determined for each powder immediately following spray drying and after storage at various relative humidities. In addition, the water sorption isotherms and reactivity to water vapor were determined using DVS and isothermal calorimetry, respectively. No sCT aggregation occurred during the spray drying process. Crystallinity depended on the amount of mannitol in the formulation. Powders containing up to 50% mannitol were fully amorphous, and those containing 70 and 90% mannitol contained some crystalline polyol. The powders remained aggregate free for over 2 years when stored below the critical RH (e.g., <20% for the powder containing 30% mannitol). Above this RH, sCT aggregation increased as a function of time. The amount of aggregate observed correlates with the amount of intermolecular beta-sheet formed, determined by FTIR. The sCT aggregation rate in powders containing 70% mannitol was significantly lower than that in powders containing 30% mannitol at all RH tested, presumably because of a higher ratio of amorphous mannitol to sCT, which inhibits the formation of beta-sheet structure. Moisture-induced crystallization of mannitol was observed in all powders stored at RH >50%. The moisture induced thermal activity trace (MITAT) offers a useful description on the physical stability of the spray dried powders. In conclusion, spray drying sCT and sCT/mannitol mixtures yields dry powders that contain physically intact peptide. In addition, sCT aggregation and mannitol crystallization in spray dried powders can be prevented during long-term storage if stored in low humidity environments, which can be easily assessed by MITAT. Copyright 2004 Wiley-Liss, Inc. and the American Pharmacists Association

Entities:  

Mesh:

Substances:

Year:  2004        PMID: 14762916     DOI: 10.1002/jps.10594

Source DB:  PubMed          Journal:  J Pharm Sci        ISSN: 0022-3549            Impact factor:   3.534


  10 in total

Review 1.  Particle engineering for pulmonary drug delivery.

Authors:  Albert H L Chow; Henry H Y Tong; Pratibhash Chattopadhyay; Boris Y Shekunov
Journal:  Pharm Res       Date:  2007-03       Impact factor: 4.200

Review 2.  Pharmaceutical particle engineering via spray drying.

Authors:  Reinhard Vehring
Journal:  Pharm Res       Date:  2007-11-28       Impact factor: 4.200

3.  Overcoming poor tabletability of pharmaceutical crystals by surface modification.

Authors:  Limin Shi; Changquan Calvin Sun
Journal:  Pharm Res       Date:  2011-06-28       Impact factor: 4.200

4.  An intestinal paracellular pathway biased toward positively-charged macromolecules.

Authors:  Khaled Almansour; Alistair Taverner; Jerrold R Turner; Ian M Eggleston; Randall J Mrsny
Journal:  J Control Release       Date:  2018-09-06       Impact factor: 9.776

5.  Design, characterization, and aerosol dispersion performance modeling of advanced spray-dried microparticulate/nanoparticulate mannitol powders for targeted pulmonary delivery as dry powder inhalers.

Authors:  Xiaojian Li; Frederick G Vogt; Don Hayes; Heidi M Mansour
Journal:  J Aerosol Med Pulm Drug Deliv       Date:  2014-02-06       Impact factor: 2.849

6.  Influence of excipients on physical and aerosolization stability of spray dried high-dose powder formulations for inhalation.

Authors:  Nivedita Shetty; Heejun Park; Dmitry Zemlyanov; Sharad Mangal; Sonal Bhujbal; Qi Tony Zhou
Journal:  Int J Pharm       Date:  2018-04-18       Impact factor: 5.875

7.  Influence of stabilizers on the physicochemical characteristics of inhaled insulin powders produced by supercritical antisolvent process.

Authors:  Yong Ho Kim; Constantinos Sioutas; Katherine S Shing
Journal:  Pharm Res       Date:  2008-09-04       Impact factor: 4.200

8.  Advancements in Particle Engineering for Inhalation Delivery of Small Molecules and Biotherapeutics.

Authors:  Rachel Yoon Kyung Chang; Hak-Kim Chan
Journal:  Pharm Res       Date:  2022-09-07       Impact factor: 4.580

Review 9.  Spray-Dried Inhalable Powder Formulations of Therapeutic Proteins and Peptides.

Authors:  Basanth Babu Eedara; Wafaa Alabsi; David Encinas-Basurto; Robin Polt; Heidi M Mansour
Journal:  AAPS PharmSciTech       Date:  2021-06-18       Impact factor: 4.026

10.  Preparation and in vivo absorption evaluation of spray dried powders containing salmon calcitonin loaded chitosan nanoparticles for pulmonary delivery.

Authors:  Chutima Sinsuebpol; Jittima Chatchawalsaisin; Poj Kulvanich
Journal:  Drug Des Devel Ther       Date:  2013-08-28       Impact factor: 4.162

  10 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.