Literature DB >> 14621973

Acid-treated yeast cell wall as a binder displaying function of disintegrant.

Tetsuya Ozeki1, Hideyo Katsuyama, Yuriko Yasuzawa, Yuuki Takashima, Takahide Kasai, Takahiro Eguchi, Hisaya Kakiuchi, Hiroshi Yuasa, Hiroaki Okada.   

Abstract

This investigation examined the application of acid-treated yeast cell wall (AYC) as a binder functioning as a disintegrant. Acetylsalicylic acid (ASA) was granulated with AYC, hydroxypropylcellulose (HPC), polyvinylpyrrolidone (PVP), or pullulan (PUL) and compressed into a tablet in the absence of disintegrant. Particle size and angle of repose of the granules, tensile strength, disintegration time, and water absorption behavior of the tablets and ASA release profiles from the tablets were measured. The surface of AYC-granules was observed with a scanning electron microscope. As was the case with the granules of HPC, PVP, or PUL, D50 of the granules of AYC increased with increasing AYC addition percentage, indicating that it is possible to granulate ASA with AYC. Tablets incorporating HPC, PVP, and PUL failed to disintegrate within 30 minutes at all percentages of binder addition because in the case of the HPC, PVP, or PUL tablets in the dissolution medium, water scarcely penetrated into the inner region of the tablet, causing no disintegration. In the case of the AYC tablets, disintegration was not detected at 3% or less of AYC. When AYC was equal to or greater than 5%, AYC tablets disintegrated in approximately 4 minutes and rapid ASA release from the tablets was observed. These results may have been caused by the following. In the case of the AYC 3% granules, ungranulated aspirin powder remained, but in the case of the AYC 5% granules, ASA powder was granulated and covered with AYC. Water absorption was observed initially; however, a plateau was reached in the case of the AYC 3%-tablet. In contrast, in the cases of the AYC 5% and more tablets, water absorption was greater and increased with time. The angle of repose of the AYC 5% granules was 25.7 degrees, which represented high fluidity. The tablets produced by compressing the granules demonstrated sufficient tensile strength greater than 0.8 MPa. The tablets rapidly disintegrated and rapid ASA release was obtained. AYC functioned as a binder at granulation; additionally, AYC served as a disintegrant in the dissolution of drug from the tablets. These results indicate that AYC affords high utility as a unique pharmaceutical additive possessing contrary functions such as binding and disintegration.

Entities:  

Mesh:

Substances:

Year:  2003        PMID: 14621973      PMCID: PMC2750634          DOI: 10.1208/pt040341

Source DB:  PubMed          Journal:  AAPS PharmSciTech        ISSN: 1530-9932            Impact factor:   3.246


  15 in total

1.  Application of some polymers in the physiocochemical design of tablet formulation.

Authors:  N N Salib; S A El-Gamal
Journal:  Pharmazie       Date:  1976       Impact factor: 1.267

2.  External enzymes of yeast: their nature and formation.

Authors:  J O Lampen
Journal:  Antonie Van Leeuwenhoek       Date:  1968       Impact factor: 2.271

3.  Invertase and disulphide bridges in the yeast wall.

Authors:  D K Kidby; R Davies
Journal:  J Gen Microbiol       Date:  1970-06

4.  Fluidized bed granulation of an ordered powder mixture.

Authors:  W J Thiel; L T Nguyen
Journal:  J Pharm Pharmacol       Date:  1982-11       Impact factor: 3.765

5.  Compression properties of granulations made with binders containing different moisture contents.

Authors:  Z T Chowhan; Y P Chow
Journal:  J Pharm Sci       Date:  1981-10       Impact factor: 3.534

6.  Isolation and composition of an alkali-soluble glucan from the cell walls of Saccharomyces cerevisiae.

Authors:  G H Fleet; D J Manners
Journal:  J Gen Microbiol       Date:  1976-05

7.  Granulation of acetaminophen by a rotating fluidized-bed granulator.

Authors:  T Kawaguchi; H Sunada; Y Yonezawa; K Danjo; M Hasegawa; T Makino; H Sakamoto; K Fujita; T Tanino; H Kokubo
Journal:  Pharm Dev Technol       Date:  2000       Impact factor: 3.133

8.  Application of acid-treated yeast cell wall (AYC) as a pharmaceutical additive. III. AYC aqueous coating onto granules and film formation mechanism of AYC.

Authors:  Hiroshi Yuasa; Junichi Kaneshige; Tetsuya Ozeki; Takahide Kasai; Takahiro Eguchi; Naomu Ishiwaki
Journal:  Int J Pharm       Date:  2002-04-26       Impact factor: 5.875

9.  Application of acid-treated yeast cell wall (AYC) as a pharmaceutical additive I. AYC as a novel coating material.

Authors:  T Kasai; T Eguchi; N Ishiwaki; J Kaneshige; T Ozeki; H Yuasa
Journal:  Int J Pharm       Date:  2000-08-25       Impact factor: 5.875

10.  Application of acid-treated yeast cell wall (AYC) as a pharmaceutical additive. II: effects of curing on the medicine release from AYC-coated tablets.

Authors:  H Yuasa; J Kaneshige; T Ozeki; T Kasai; T Eguchi; N Ishiwaki
Journal:  Int J Pharm       Date:  2000-11-19       Impact factor: 5.875

View more
  1 in total

1.  Design of rapidly disintegrating oral tablets using acid-treated yeast cell wall: a technical note.

Authors:  Tetsuya Ozeki; Yuriko Yasuzawa; Hideyo Katsuyama; Yuuki Takashima; Takahide Kasai; Takahiro Eguchi; Hisaya Kakiuchi; Hiroshi Yuasa; Hiroaki Okada
Journal:  AAPS PharmSciTech       Date:  2003-12-31       Impact factor: 3.246

  1 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.