Formulation parameters affecting the performance of coated gelatin capsules with pulsatile release profiles.

The objective of this study was to develop and evaluate a rupturable pulsatile drug delivery system based on soft gelatin capsules with or without a swelling layer and an external water-insoluble but -permeable polymer coating, which released the drug after a lag time (rupturing of the external polymer coating). The swelling of the gelatin capsule itself was insufficient to rupture the external polymer coating, an additional swelling layer was applied between the capsule and the polymer coating. Croscarmellose sodium (Ac-Di-Sol) was more effective as a swelling agent than low and high molecular weight hydroxypropylmethyl cellulose (HPMC; E5 or K100M). Brittle polymers, such as ethyl cellulose (EC) and cellulose acetate propionate (CAPr), led to a better rupturing and therefore more complete drug release than the flexible polymer coating, Eudragit RS. The lag time of the release system increased with higher polymer coating levels and decreased with the addition of a hydrophilic pore-former, HPMC E5 and also with an increasing amount of the intermediate swelling layer. The water uptake of the capsules was linear until rupture and was higher with CAPr than with EC. Soft gelatin capsule-based systems showed shorter lag times compared to hard gelatin capsules because of the higher hardness/filling state of the soft gelatin capsules. The swelling pressure was therefore more directed to the external polymer coating with the soft gelatin capsules. Typical pulsatile drug release profiles were obtained at lower polymer coating levels, while the release was slower and incomplete at the higher coating levels. CAPr-coated capsules resulted in a more complete release than EC-coated capsules.