A tilting device for three-dimensional microscopy: application to in situ imaging of interphase cell nuclei.

The resolution of an optical microscope is considerably less in the direction of the optical axis (z) than in the focal plane (x-y plane). This is true of conventional as well as confocal microscopes. For quantitative microscopy, for instance studies of the three-dimensional (3-D) organization of chromosomes in human interphase cell nuclei, the 3-D image must be reconstructed by a point spread function or an optical transfer function with careful consideration of the properties of the imaging system. To alleviate the reconstruction problem, a tilting device was developed so that several data sets of the same cell nucleus under different views could be registered. The 3-D information was obtained from a series of optical sections with a Zeiss transmission light microscope Axiomat using a stage with a computer-controlled stepping motor for movement in the z-axis. The tilting device on the Axiomat stage could turn a cell nucleus through any desired angle and also provide movement in the x-y direction. The technique was applied to 3-D imaging of human lymphocyte cell nuclei, which were labelled by in situ hybridization with the DNA probe pUC 1.77 (mainly specific for chromosome 1). For each nucleus, 3-D data sets were registered at viewing angles of 0 degrees, 90 degrees and 180 degrees; the volumes and positions of the labelled regions (spots) were calculated. The results also confirm that, in principle, any angle of a 2 pi geometry can be fixed for data acquisition with a high reproducibility. This indicates the feasibility of axiotomographical microscopy of cell nuclei.