Single-wall carbon nanotubes under high pressures to 62 GPa studied using designer diamond anvils.

Single-wall carbon nanotube samples were studied under high pressures to 62 GPa using designer diamond anvils with buried electrical microprobes that allowed for monitoring of the four-probe electrical resistance at elevated pressure. After initial densification, the electrical resistance shows a steady increase from 3 to 42 GPa, followed by a sharp rise above 42 GPa. This sharp rise in electrical resistance at high pressures is attributed to opening of an energy band gap with compression. Nanoindentation hardness measurements on the pressure-treated carbon nanotube samples gave a hardness value of 0.50 +/- 0.03 GPa. This hardness value is approximately 2 orders of magnitude lower than the amorphous carbon phase produced in fullerenes under similar conditions. Therefore, the pressure treatment of single-wall carbon nanotubes to 62 GPa did not produce a superhard carbon phase.